Find a local Tasker to inspect your Holden near you

I have purchased a new spark plug - tried to replace it myself - but I believe the spark plug is seized - I could not get it out - it's cylinder 3 on the VF Series 1 V6 Holden Ute... should have been an easy job but I couldn't get the spark plug out and I don't own an accurate torque wrench.

Install supplied Android head unit (9.7” Tesla-style, Astra J type) in 2016 Holden Cascada. Unit, plug-and-play harness, canbus box and fascia all supplied. Dash partly disassembled already (gear surround popped). Need: old unit out, new unit wired incl. canbus/GPS/mic/USB, steering wheel controls + factory reverse camera working, canbus configured, dash reassembled.

Holden Commodore body repair. The damage as seen in the picture.

Detach booster from firewall and brake pedal under dash on HZ holden.

Need someone hands-on with petrol engines to partially disassemble a 2016 Holden Cruze 1.8L engine (engine stays in car). Work involves removing cooling, intake, ignition, exhaust, head, timing, sump, and piston assemblies to hone cylinder walls, then reassemble with new piton rings and others that would be replaced in this type of re-assembly. Parts & gaskets supplied. Springwood location. Please briefly describe similar work you've done. The vehicle is located on level driveway in front of house. Nose of the vehicle facing the street for easy access. EDITS: If this is a rebuild, best to rebuild engine in a controlled environment: I understand the ideal nature of things. The effect may be an engine rebuild, but that is not the purpose. I have the skills to carry out the above task, but I currently do not have any time, hence the post. Objective is to restore compression in the cylinders, so, just a hone, replace rings, put the pistons back in with new con-rod bearings, re-assemble everything else, replacing gaskets. Resale value of these cars is driven to the ground by the reputation these have. Bought it as a daily driver until I can get a better daily driver, but ran in to troubles, so trying the make the best of a bad situation. Thanks again, but I am not in an ideal situation to do an ideal rebuild.

Looking for help changing clutch in an rg colorado. Have got the gearbox disconnected need to pull it out and do the change over and reinstall. It has a welded crossmember so another challenge i am facing. Potentially cut the crossmember out or if anyone has experience in doing them even better. Look forward to hearing from you

Taking off the old head unit and replacing it with a new one , also putting up the wiring for the sound system, Holden Captiva 2012 model

I want to install brand new Dash camera in my TOYOTA KLUGER 2024.

Im needing a mobile mechanic to install a alternator for me in my Holden Astra 08 its diesel. I already have the alternator i just need a mechanic to install it its urgent because i need my car for work

Need of airbag replacement on my 2008 Holden Barina. I had a slip up and disagreement with a concrete bollard while parking. The car has no other apparent issues. Need - steering wheel airbag, - passenger front airbag - passenger front seatbelt - SRS reset

Just need Holden Barina Jump start. Preferably on weekends

I think there is a Screw or a hole in my back tyre ( need it fix tomorrow after 3:00 pm)

Holden Captiva 2010 Diesel Automatic 2.0 Litres Alternator replacement is required; needs to be a mobile mechanic who can come here (kallangur 45903) and do it. I already have the alternator. Just looking for a fixed replacement labor cost for the job.

Run fuel lines and finish setting up aftermarket fuel rail on 5 litre get my Holden 5 litre running need to be done asap

Have the pads, Lynbrook after 4pm or Brighton area during the day

Holden Colorado 2020 head unit install with reverse camera. 2nd reverse camera on 04 Prado. Happy to pay per hour or job rate.

Rear indicator bulb needs changing. Old one is completely stuck. I have the replacement bulb. Hopefully today as I need to drive it to work in the morning.

Brake pump part is broken, got new part. Need someone to install

Please remove faulty existing upper radiator hose and install new radiator hose from radiator to engine block already have the hose just need the labour to fit it please

Need a basic service done on a holden sv6 2017 - need mobile as we are on holidays and have just purchased the vehicle from here today