Find a local Tasker to inspect your Ford near you

Hi there, I need a qualified mechanic or auto electrician to scan and clear an airbag warning light on my 2022 Ford Ranger Wildtrak. The light has come on a few times before and usually goes away, but it’s stayed on today. I’ve already checked and reconnected the plugs under both front seats and moved the seats forward and back, so it’s likely a minor sensor or reset issue. The vehicle is being traded in on Tuesday, so I need this sorted as soon as possible. I’m located in Mango Hill but happy to go to your place if easier. It should be a quick job involving a diagnostic scan and code reset. Please confirm your availability, experience with Ford systems, and price when making an offer. Thanks!

looking for mechanic to swap a gearbox over,complite ready to go . I can drive also To your garage. facon 4 speed 2008 BF model

I have two side steps for Ford territory that only somebody to install them

I lost my car keys for a Toyota Corolla and Ford Transit, need replacements

Ford Focus ST 2015 service, had a major service not long ago, not running great, need a oil change, coolant, new spark plugs.

JUST NEED HEADLINER REPLACED IN 2014 FORD FALCON FGX SEDAN - HAS STARTED TO SAG - FRONT AND BACK Standard FGX Falcon Grey is fine (CAR EXTERIOR IS BLACK)

Hi all I'm needing an experienced person to change over my front and back brake pads on my 2013 Ford Mondeo Wagon. I have the pads already and I'm not sure if all are needing to be replaced there's a squeek noise when braking. None of the pads have sensors. I have a carport or I could come to you if you're not too far from me in Lutwyche.

Hi, I'm looking for someone that can help remove the front steering wheel airbag from my Ford ranger, I had someone switch my steering wheel over but I need to get the airbag back off so I can change the buttons over from the old steering wheel, I should be okay to finish the job once someone can help remove the airbag :)

Seeking a Pre-purchase Vehicle Inspection for a 2020 Kia Sportage - Seaford.

Need oil change for Ford Falcon futura 2007 and also filter replacement

Hi, I need help installing a front and rear dashcam with a hardwire kit (I have the kit and fuse cables) in my Ford Everest Trend (2019). Cable management is important - would like them hidden. Flexible schedule; please share your availability and quote. Thanks!

I will provide starter motor just need someone to fit it . only a thirty minute to sixty minute job .

You will need to supply or have access to cheap replacement window. Would like done asap but next few days is ok

UHF Radio and antenna supplied (did not come with ring terminals. Ideally would like it spliced onto an accessory power line so radio is only on when ignition is on.

Car radio / dashboard console (controlling radio, CD, phone, setup menu, etc) not responsive. Radio was working but sometimes would be unable to change stations/volume, etc but would then come good after maybe 15 minutes of driving. I thought this might suggest a battery issue but had the battery checked and all OK. Some research online suggested doing a "hard reset" by disconnecting the battery for ~10 mins. Did that, after reconnecting battery, the console is in a dead state (displays time/date but does not start 'Ford Audio', as expected). Have replaced the 2 relevant fuses, hasn't helped.

My Ford fiesta car radio plays and the dashboard bit lights up and displays. But the buttons on the radio and steering wheel don’t work so I can’t change the channel, turn volume up down etc.

Install a towbar and wire up

Take 2014 Ford Territory to Bankstown to repair tailshaft. Key is with me 5hrs away and tailshaft has been taken off.

I have purchased a brand new alternator however I need to get it installed ASAP. I’m flexible with where the job takes place as I am able to get the car towed within 25km radius for repairs but I would prefer if you would be able to do it here.

I would like an Anderson plug to be installed under the existing trailer wiring harness. I'm happy to organise the following: - 50A anderson plug - Cable (somewhere between 6-10 AWG - keen for your recommendations) - Trailer Vision 175A Black Exterior Connector Cover Assembly - 200A Subfuse (likely something like this - keen for your thoughts) https://www.altronics.com.au/p/s4343-200a-12vdc-high-current-spst-automotive-relay/ Please quote for your labour to complete the install of the following: - Anderson plug housing as indicated in the photos - Cable to vehicle alternator - Provided isolator - Fuse Please let me know if there is anything I have missed. I've attached an image of the current trailer wiring harness and an installed one from another vehicle to show what I'd expect it to look like once installed.