Find an experienced handyman in Craigburn Farm

Drawers repairs Door Handle repairs Towel rack Replace bulbs/ light switches

I would like to repair my coffee table glass edge which is damaged: - one part of the glass edge (12mm width) is damaged so need the edge to be re-cut and smoothed by 2-3mm. - table is 117cm x 117cm Either complete job at my house (Craigburn Farm) or I can bring glass table to your shop

Brush fence top roll lifted and tightened

Would love someone with carpentry skills to do some wall panelling for our lounge area and hallway. We would love it done asap of possible

Tiles lifting and water going through

Remove small branch stuck in a cut leaf birch tree in our backyard. Also tighten loose interior door handle and sliding glass door which is also a little loose and a bit tricky to close.

Re-attach door on rollers. Add 2 shelves to inside and latches attached to front shutters.

The PS4 disk compartment works but is bent. Need repaired asap.

I need a handyman / carpenter to replace existing mortice lock to Eufy smart lock. Whats required: - Cut or chisel existing latch to fit the lock - Install the new roller barrels - fill in the gap with small piece of timber on the door or alumunium frame - I can replace myself but this has to be done properly to make it seamless. You must be experience and have done this before. Due date: Before Sunday, 18 February 2024

Wall pepar to be hang on feature wall in 2 bedrooms - Due date: Flexible

Gliderol door not going up or down when I push the button. It has happened before and it was the tension apparently - Due date: Flexible

Need damage repair for large oak dining table. See pictures - Due date: Flexible

I have a small irrigation system assessed and need a quote to repair. - Due date: Needs to be done on Wednesday, 23 August 2023

Cut and install single line of pavers as per photo. Pavers supplied by customer . - Due date: Needs to be done on Wednesday, 2 August 2023

I need a handyman / carpenter to replace existing mortice lock to Eufy smart lock. Whats required: - Cut or chisel existing latch to fit the lock - Install the new roller barrels - fill in the gap with small piece of timber on the door or alumunium frame - I can replace myself but this has to be done properly to make it seamless. You must be experience and have done this before.

Machine groove in bottom of door and install in position with fittings supplied. - Due date: Flexible

Put up pictures steel frame house - Due date: Flexible

Installing a wall mounted clothesline - Due date: Flexible

Hi, I need someone to fill in these holes where we removed a couple of doors. I tried using builders bog but it didn't cure for me.

Install an awning on the roof rack of my car. Can meet you closer to the city