Find an experienced handyman in Chipping Norton

Cylinder removal and replacement,the cylinder seems stuck and I don't have the tools to remove it.

One dent in rear door need popped out no paint correction needed and one very small dent in passenger side. Sliding door also need popped out.

Assemble chicken coop in my back yard on the concrete floor

This is another job to change existing fit out but would like to get a bit more space and changes. Also need to soundproof existing boardroom and offices.

Wall mount The ATX® Wall Bar Gym on a brick wall in garage. Pictures attached

Hello, I have a mirror and 4 paintings to hang in my house. I also have a dog flap to be installed on a security door as pictured. Wednesday or Thursday morning this week would be great. Thanks, Angela

After someone to assemble a FORCE USA G3 all in on trainer. Link below https://www.gymandfitness.com.au/products/force-usa-g3-all-in-one-trainer-v2?variant=39910547357768&gad_source=1&gclid=Cj0KCQjwhMq-BhCFARIsAGvo0KcX3I_RhVh-bWgCP7Nlpz0sj1E1NpCd4khMJxVLoSQmrVOCWC6CNYIaAi1dEALw_wcB https://www.gymandfitness.com.au/cdn/shop/products/ForceUSAG3_0001_2.jpg?v=1724290976&width=990

5 walls need repairing due to cracks

Already have a concrete slab and just need to set the shed up. It is a Bunnings flat pack shed. The dimensions are 3 x 0.78 x 1.95. Anchor kit is supplied in the kit.

I have purchased a ceiling fan and need installation

Need a handyman to install curtain rods for the house, there are 9 curtain rods in total

I purchased 2 ceiling fans and need them installed at my unit. Currently there is a ceiling fan in one bedroom, so this needs to be replaced. The other bedroom has a light so the fan can be placed where the light currently is.

Accidentally bumped the car to the last panel of garage door, just need an expert hand to fix the bent, fortunately nothing has broken or out of railing.

Install a solar panel awning in a brick wall. We have all parts of the awning, basically two plastic arms, dynobolts and a plastic cover. Tools will be required, to drill holes in a brick wall install dynobolts and afixing cover can be done by hand. we are flexible with time. Currently there are two arms with dynobolts in the wall, these need to be removed as the holes were drilled in the wrong place.

Needing 8 security camera mounts, 5 toilet roll holders and 5 Hand towel dispensers mounted. All will require drilled into concrete Has to be done after 23/10

We have white plantation shutters & three of those have broken off its position. Looking to refit back in place may require a special type of screw & tools & carpentry skills without breaking the bank

The door is stuck and it does not close or open properly. I think the runner may be the issue and needs a new runner. I am happy to pay for the runner separately. Door is not damaged. Please purchase runner ready to fix just in case you need to replace the runners

Sagging ceiling repair. Need gyprock plastered too.

Aircon duct in roof is currently as is in the photos. Please do the following 1. Hang all straps to neaten all duct work 2. Remove bends to allow more airflow 3. Fix and patch up any holes in duct and make sure everything is recessed so I can install insulation later on. I have not been up in the roof and this was just a photo from building inspections but the photo below is the roof area

I took off a kitchen cupboard that i need put back also fix another cupboard