Find an experienced handyman in Bli Bli

We need to update the cupboard above the fridge to 2 hinged doors. The cabinetry has been made. We just need someone to install it. The new doors are push to open. The photos below; 1 is of the cupboard that need replacing (with no handle) 1 is of the type of doors that will be used instead. Thanks Kate

Looking for someone to install a uhf into my ranger

Plaster around / tidy up plaster areas as per pictures please

One wall with top right triangle missing 3550 x 2350 High quality stick down wallpaper I have no idea of what to charge

One wall with right corner cut out. 3550 x 2350 Stickdown Wallpaper

I have a keylock I purchased from Bunnings that I need a handyman to mount onto a brick wall for me please.

Require someone to install a Ring Video doorbell onto my brick wall near my front door please. Requires drill and mount

Deck repair needed from plumbing job. Also need a few rotted boards replaced.

Install Bunnings flat pack laundry cabinets on two walls - one cabinet only under bench. Two bench tops both walls.

I need a barn door installed in an ensuite All hardware supplied

I want to repair a broken tile in my shop. I can't find the same type of tile, so please glue it back together so it doesn't fall off anymore.

Require someone to install a Ring Video doorbell onto my brick wall near my front door please. Requires drill and mount

Replace rollers in 3 40 year old aluminium sliding doors.

Thought I could fix on my own but I fucked up.. Need towel rail installed back on wall. Not sure how much will NEG

Need a medium size picture frame hung. Preferably hardware supplied. Need done properly - hung on 2 x d hooks. I attempted myself with wire between 2 x d hooks - not successful (d hooks broken on back).

We ordered inside mount roller blinds and they don’t fit because the window frames stick out too much at the tops. Just need the top edged grinded back on an angle to allow them to fit when rolled up! There are about 27 corners to grind off at a 45degree angle, as per second picture.

Refurbing a chest of draws and didn’t realise the challenge of attaching these handles No use buying a tool as I won’t need it again. I will also be able to assist with drilling and fitting, it’s mainly the measuring of the holes!

Need gym rig to be elevated(about 15cm) to allow for swinging off the top bar without feet touching the ground. Needs to be stable on ground. Not sure how this can be achieved but was thinking some sort of welding metal to the bottom frame. It cannot be fixed to the concrete. Have no idea how much this would cost so task price is flexible

Replace bottom engine mount 2013 Ford Focus MK3 I will supply the part

I have some plaster setting required in a kitchen renovation