Find a professional gyprocker contractor in Castle Hill NSW

Gyprocking of new beam, walls, etc

Need drywall endcaps installed on 4x recently extended wardrobes. Studs are 90mil. Need the tops and sides done. Gyprock used must be 10m thick. Drywall should be plastered and sanded ready for paint by end of job. Tasker should have all required tools including supply of the drywall or corner beads required. If the tasker completes the job with no hassle or fuss and on time or early, tasker can expect a $ 7 hundred fifty dollar tip

We have removed a wall and doors. This task is for the following - Supply & Install any ceiling framework required to repair ceiling - Supply & Install gyprock to ceiling framework - Supply & Install 90mm cove cornice where required - Gyprocker to set and sand all areas as required (includes basecoat, topcoat and sanding) - Remove existing half/cut tiles from near existing wall - Supply & Install skirting, to best match existing, where required - Remove trade waste & tidy site

Quick job to put up new ceiling and cornices in bathroom. See image 3500 x 1900 We will remove existing gyprock and insulation down and have it ready. I will provide: Gyprock Cornice New exhaust fan New insulation batts 1kg of Gyprock acrylic stud adhesive (see images) 2.25kg of topping compund (see images) 1 roll fibreglass joint tape (see images) Just come with your magic tools and experience to get the job done fast! MUST BE RELIABLE!!!

I have an attic ready to install Gyprock. It is 12m long by 3.5 m wide. Walls 1.9 m high & a vaulted ceiling. There are three skylights that need to be square set. I have a Makita Gyprock screw gun & a sheet lifting device. There are 36 gyprock sheets in the attic & these are 3m by 1.2m. I am able to assist if necessary.

Attic ready to install & plaster gyprock to 12 m by 3.5 m walls 1.9m to vaulted ceiling. I have the gyprock sheets in the attic (32 in total) 3m by 1.2m I have a sheet lifter & also a gyprock screw gun. I also have three skylights that need to be square set.

Complete TV media wall with fireplace Tv wall cover frame 2.8m wide x 2.4m high x 0.4m deep / Gyprock + niche + tv bracket install + fireplace placement and connection

Need tile removed from wall, it seems to be glued? and I assume the gyprock will be damaged behind it and willl need to replace.

I’m looking for a skilled Gyprock/plaster repair specialist or handyman to repair a section of ceiling that was damaged due to a leaking skylight (the leak has now been fixed). Scope of Work: • Remove or clean up the damaged Gyprock section • Patch and repair the affected area professionally • Sand and finish the repaired area seamlessly • Color-match and paint the ceiling so the repair blends with existing ceiling finish • Ensure clean-up after completion

Repair gyprock wall where door handle has gone through it. Needs to be finished to a stage ready for me to paint the wall myself.

gyprock were an air vent used to be

Got a whole on the Gyprock wall (Thanks to our talented kid) requires repair and paint matching as we are renting the propetry. You might be able to access the back of the wall through the attic.

Gyprock and square set tops of the Walk-in -robe . Room measures 3.3 x 1.5x 2.4 . Prior experience preferred. Please provide a quote and your availability. Thank you

Patch hole in garage ceiling. Approx 300mm x 300mm. Patch and sand, ready for painting

Gyprock ceiling and walls repair works Revised scope

1. There is a small hole in the gyprock which needs to be patched 2..some water stains on the ceiling which needs to be painted

Fill a hole in two bathrooms fire rated ceiling as a fan is removed. The ceiling has 2X13 mm gypsum boards. 25x33 cm (approx )

Need to get amthe ceiling wall gap fitted with gyprock

Hole in the gyprock wall needs fixing

Hello, We had some old water damage impact out Gyprock in the garage bulkhead. The leak has been fixed, but now the bulkhead Gyprock needs replacing. Timber frame and angle in place. Can supply all materials.