Find gutter repair professionals in Kedron

We’re looking for an experienced, appropriately QBCC-licensed builder to inspect the roof eaves/fascia on the western side of our two-storey home in Kedron. The gutter has pulled away from the house and is noticeably sagging. Before arranging a gutter repair or replacement, we need the supporting timber, fascia and eaves inspected to determine whether there is wood rot, water damage or another structural issue that needs to be repaired first. The inspection area is at two-storey height, so you must provide a suitable extension ladder and all required safety equipment. We would like: • Inspection of the fascia, eaves, supporting timber and gutter attachment points • Identification of any rot, water damage or structural deterioration • Advice on what repairs are required before the gutter can be fixed • Photos and a brief written assessment of the findings • A separate repair quote if building work is required Please include your QBCC licence number, relevant experience and confirmation that you are equipped and insured to work safely at two-storey height. The initial Airtasker task is for the inspection and assessment only. Any repair work can be quoted separately after the inspection.

I have an approximate 3m length of existing guttering (circled in red) that needs to be replaced. I think it also needs to be extended such that it properly captures water running off the roof at the gable front edge. For years we've had a downpour at the ground level when it rains. The closest match I have been able to find is Qld Stramit Quad but its not 100% perfect so I'm not sure if a replacement "section" could be successfully re-joined with the existing section (in blue). Else the red and blue sections both may need replacement.

Gutter replacement and flashing installation

Obtain services location diagram required for excavation through nature strip / pathways. Concrete cut section of pathway at the right hand side of the property in preparation for excavation work. Jackhammer and remove concrete pathway section. Excavate trench from the front right hand corner to the existing kerb outlet. Supply and installation of a length of 100mm PVC to connect the exisiting down pipe to the street. Bed pipework using required drainage gravel to provide adequate fall to street. Backfill all works with exisiting site soil and remove waste concrete from site.

I’m looking to have a small section of my fascia and soffit repaired. It is a double story house with timber fascia and fibre cement soffit. It looks like the barge cap on end rafter timber was too short, allowing water to get behind gutter and leaking into eave destroying the softwood dress timber. I'll be replacing the gutter shortly so looking to have this completed prior