Find a local glass fencing contractor in NSW

Pool gate latch needs tightened or replaced

Reinstall glass work total 9 panels one wil be in diagonal on stairs, all the g spigots and standout has to be Re drilled ,all the fixings are on site , just labour will be needed

- Replace shattered pool glass (Glass has been cleared) - Fix hinge on gate and latch so it self closes again

Pool fence gate post is wobbly and pool gate is not automatically locking

Need a pool glass fence supplied and installed within the next 6 weeks.

I’m after some quotes for a pool fence

Hi everyone, We recently bought a house in NSW and found the pool barrier is non-compliant. We’re looking for someone experienced with pool fence compliance upgrades (AS1926.1 / NSW rules) who can recommend the cleanest and most budget-friendly solution and carry out the work. 1) Glass pool fence issue (Photo 1) • Current glass barrier height is about 1.0m • It needs to be 1.2m • We want to know the best option: • Can a 20cm glass extension/top-up panel be added to the existing glass? • Or is it better/cheaper to replace the glass panels with 1200mm high glass? • If extension is possible, how is it fixed (clamps/channel/top rail) and will it pass inspection? 2) Boundary wall / climbable issue (Photos 2+) There is a wall around the pool boundary that is approximately 1.8–1.9m high, but because there are small garden/raised areas near it, we’ve been told it may be considered a climbable point. Someone mentioned that once the glass fence issue is fixed, we may be able to apply for an exemption because the boundary backs onto a park (not a neighbour) — but we’re not sure what’s actually possible. What we need ✅ Inspection + clear recommendation ✅ Quote for the best fix (budget-friendly + clean finish) ✅ Installation/work completed properly ✅ Ideally supply any compliance paperwork / coordinate with certifier (if you can) Please let me know your suggested solution and rough cost range. Thanks!

I need someone to reinstall 9 panels 2100x 1200 is all on site just need labour to reinstall

I need a pool fence done on one side of the pool with the gate. Total length is 6.5 m. Please see the attached photos. Has to me complain with the pool rules

Need to get a glass fence on 2 sides of our backyard deck. Dimensions: 1 side - 4.63m 2nd side - 5.46m

Hey guys I need a glass gate panel installed I have photos of where it is & have taken photos of our pool gate

Need a temporary pool fence that I can keep for summer and remove in winter and then put back up next year. I have a fence solution in mind and would like to discuss this with the successful trade person. Person must have tools including a drill that can go through brick and concrete. Please do NOT apply if you are not fluent with this task. I am assuming it will take 6 hours. Happy to agree an hourly rate if it goes over this cost. Ideally get this done next weekend. I would like to order them fence materials this weekend so ideally need to have an hourly rate with you, on site, to chat through the solution with you. Happy to pay for this hour on site immediately and that is separate to the air Tasker cost for this task.

I've purchased the Enduroshield, looking for someone to clean the fence and apply it as per instructions. Approximately 25 meters of pool fencing.

I have 2 panels of glass fence to be removed and used in another direction. I have straight line fence and want to make a u shape return in middle to allow for a new sitting area. Will need be glass panels to fit 1200mm high and 3260mm total length. Also need one at 900mm wide. Spigets need to be core drilled into concrete .look at my picture the red line is marked for the new shape. Blue is to remove existing glass.

I need to have pool fencing panels and gate installed to section off a put of my yard. I'm unsure of the measurements so I will need someone to come out and measure first.

I had a pool fencer come and install my glass pool fence but did not do a great job and is tilted. image attached,.

A 1m panel of our pool fence has fallen (during recent high winds), and needs repairing

Just need someone physical to help take off a pool glass panel then put back on a raised deck. A few other minor adjustments needed on the day but not a lot to do. About 6hrs I estimate. I’m driving down from the Kingscliff area so can pick up and drop off if needed.

Pool fence cut from the ground (two posts) Then secure against side of house and side fence (will need two pieces of wood to make fit), need you to get screws to secure to sides

Supply & Install glass pool fence with gate around 9M total. Quote to supply and install the glass fence See photos for details