Find a professional gate installation in Sorrento VIC

Aluminium slats need to be cut to length and installed on the gates. 36 slats in total to be cut

Install a track for a sliding gate and base for motor. Excavation and materials including reinforcement and finishing. No fitout or gate equipment required. Concrete track to be level, aligned and designed to support gate and motor, ready for fencer to install track, gate and motor. Power/conduit already installed, so just need concrete boxed/poured to suit. Photos included.

I'll purchase the materials directly and the task is for the labour to plan the gate and materials, pickup the materials (I'll pay the supplier for them), build and install the gates. The gate gap is about 3.6m wide and the gate will be 1.2m high. There are existing square wooden posts on each end already which can be used. I require you to arrange the materials, however I'll pay for them directly from the supplier/s. I'd like a metal frame with wooden battens attached. The frame would be ideally black powder coated, otherwise stainless steel). I assume it needs three hortizonal tubing (top, middle, bottom) so the timber won’t twist. I think 3.6m is too long to hang a single gate, so most likely it will need to be two gates with a latch and drop rod. The battens should be Silvertop Ash or Spotted Gum battens reasonably close (e.g 32mm battens with 20mm gaps), running vertically. Please provide your airtasker quote for your labour, and what plan you have for the materials required (which I'll pay for - please tell me how much they will cost from your supplier/s) Thanks

Width about 3.6m and height 1.2m. Square Wooden posts are existing and to be used. Metal frame (ideally black powder coated, otherwise stainless steel). I assume it needs three hortizonal tubing (top, middle, bottom) so the timber won’t twist. Silvertop Ash or Spotted Gum battens reasonably close (e.g 32mm battens with 20mm gaps) Please quote for materials and labour, but breakdown separately and list the material included. Thanks

Repair automatic gate locking mechanism

3.5m timber sliding gate. Needs installation including concrete footing. We have all fixtures including track, post, guide. Refer to photos for details. Ask any questions required to quote.

The gate's hinges have rusted. Need to supply hinges, and weld them on to gate. Fix to post and hand gates. Old hinges to be removed. Unsure of how much this should cost - you tell me.

Gate does not close unless pulled

need the fence to be banged down into the ground and the gate just slightly adjusted so that it doesn’t catch. Also alan key tighten up the toilet roll holder - Due date: Needs to be done on Wednesday, 24 January 2024

Metal gate hinge for wooden gate has broken. New hinges need to be supplied and installed and then gates realigned. May require second pair of hands. Supply of hinges not included in suggested amount - Due date: Before Tuesday, 19 December 2023

Our glass pool gate is not closing properly and needs adjustment or replaced hinges - Due date: Before Thursday, 7 December 2023

Just need the gate removed so we can get a barrel through and then reattach - Due date: Needs to be done on Monday, 10 April 2023

The hinges have dropped, it slams when it closes and it doesn’t close properly - Due date: Before Monday, 30 January 2023

Hinge on garden gate broken. Repair and replace 2 hinges - Due date: Flexible

Have a contractor for auomatic sliding gate Need excavation and retaining walls to create recess for concrete and track to be laid by gate people. Approx 5m and 1m at deepest point and .3m width - Due date: Before Thursday, 21 April 2022

Unfortunately my gate hinge has rusted through and needs to be replaced. Need someone to repair the metal gate frame and attach a new hinge.