Find an experienced fireplace installation professional in South East Perth

Old jarrahdale innovator fireplace/box and stud wall to be removed, and replaced with a freestanding new firebox (glass and cast iron).

Rendering the fireplace to cover all the white bricks

We have recently moved homes and have unearthed a previously boarded up fireplace. The brick facade is hanging off the wall and needs to be replaced. Looking for a bricklayer/mason to create a new brick facade to generate an attractive focal point in the room. We will want the fireplace to be useable after, not just decorative. Have included a photo of the current state and a photo of our inspiration.

Disconnect and remove existing heater and later (Nov) Install illusion Azura 3 with flue into existing chimney that previously had Rinnai gas heater installed. Initial advice to ensure space is ready when heater arrives and then install. Existing heater is ready to be removed now so that we can resurface hearth and surrounding wall to modernise look.

Remove bricked in fireplace (gas heater will have already been disconnected and removed) The brick surround has built out over the original wall, I think you’ll need a masonry chisel and hammer or an angle grinder to remove brick by brick, but unsure!

Wall to look integrated with VJ boards behind and shelving either side of false wall

I need my electric heater wall mounted, my toddler has started to climb so need this done ASAP. I can send better photos of required. It looks like there is a wall mount provided on the back of the heater as seen in the photos. Otherwise I don't have a mount to use.

Cut through tin roof instal flue kit for fire place

The fire starts but doesn't spread across the fireplace.

I have a gas lit fireplace. It is lit up but the fire doesn't spread.

I’ve got a little Jarrahdale Swagman wood heater/fireplace in my home in Redcliffe and I’ve noticed some rust forming at the top of the flue where it meets the ceiling. In the recent rain it’s started to drip down the flue. There’s also minor cracking in the ceiling nearby around the top. Seeking a quote to: - Inspect the flue pipe and identify the source of the moisture - Look at the flashing to see if water’s getting in - potential inspection of roof space if required - Advise on repairs or maintenance might be needed It’s a single-storey place, and the roof is relatively easy to access.

Looking for someone to adjust the fireplace slightly will also need someone to brick up a fire rated wall in the near future once permits go through... Thank you Looking to get the fireplace done asap

Remove entire fireplace and plaster board the remaining hole, supply and install skirting board. No painting required/no removal of waste required.

Looking for someone to install a small wood fire heater in my living room. There is currently no fireplace there, but there is a gas outlet there, not sure if that causes any issues? It is a single story brick house with roof tiles. Scandia Warmbrite 140 Indoor Wood Heater Thank you ☺️

I need a flatpack electric fireplace built. :)

I'm looking to have a double sided fireplace installed in my house. I haven't purchased it yet, but I'm considering the Lopi 4415ST double sided gas fireplace. The wall already has a gas outlet. We would need stud framing for the unit and the hole in the wall to be knocked out.

Currently have a brick fireplace. We are hoping to have a Victorian style mantle installed instead. Photo of current fireplace.

The fire backs onto the adjoining garage. Existing flue exits from a 45 angle and the smaller flue diameter runs vertical through a galvanized steel roof. Old and new flues will be of identical diameter and these, along with the gas fire will be available on site.... photos attached. Delivery expected this Thursday or maybe next. Cheers Bob

I would like 2 of my unused fireplaces sealed. Would like the most economical method please. But also open to suggestions.

I need a 55 inch LG mounted to the wall above fireplace. I don't have the wall mount, but I think it needs to tilt, I would like some help with which one I need and will grab before install. (unless you have correct one and i will adjust price)