Find experienced local fencing contractors in Norman Park

I need a small section of my timber fence patched up to make it dog-proof. Not a full repair — just adding two short boards to close off a gap and stop my dog from squeezing or chewing through. I’m open to your suggestions for the best way to block it off. I’ve considered chicken wire, but our Labrador puppy tends to chew everything, so solid boards might be better. You’ll need to bring your own tools, materials, and fixings (I can reimburse material costs). You may need to come by first to measure before starting the job. Ideally done as soon as possible — our puppy is getting very curious about that section of the fence!

The gravity latch on our side gate is really stiff and only closes if you slam it. Not sure what’s causing it. We’d also be open to installing something more secure or dog-proof if that’s a better option. Looking for someone handy with gates or fencing to take a look and fix.

I have a decorative bamboo fence that has fell backwards and needs securing

Quote to build a fence. If the price sounds ok I’ll need a written quote for body corp approval. Fence 3.1m by 2m high from patio to retaining wall then 1.6m by 1.18m high above the retaining wall (which is 82cm high). The top of the fence will go straight across. One pic shows what it needs to look like to match other fences on site. The other pics show the actual site

Fence work timber New shelves With timber

Hello, Looking to spend $800 max. Need something installed in the next day or 2. Please 🙏 I need a gate put on the front on our driveway urgently. We are getting a double carport build in the next 3 months so don’t want to spend a lot on a fancy, long term solution. Just something to keep the dog secure until then. Also need the gap blocked underneath the pedestrian gate with a panel. Thanks

Looking for builder/handyman to remove and dispose of 2 x iron/metal gates (and fittings) as pictured. Carport gate is 2400 x 2000 and side gate is 2000 x 1000.

We need our front fence painted. The fence has 80% of first coat done. I want 2 more coats with enough time between to dry completely (do over a couple of days maybe?) I don't want the stainless latch painted at all but the hinges can be as was done on 1st coat. I expect a good and detailed job, making sure you get into every corner and joint properly, including in and around the metal gate frame. I will provide paint. You to need to provide tools/brush etc. You will need to wipe down and clean all the dirt off the fence first. A sheet or cardboard will need to be used to not spill onto the concrete. There is no grass in yet and just dirt, so use a sheet or something at the bottom to stop dirt being dragged in. I expect you to do under the bottom rail properly and all the way down the rails to ground.

My pool gate has stopped closing automatically. It looks like the alignment is slightly off, but could be pretty easily fixed. See pics

We need this sort of fence to be built Its approximately 20lm and 1.8m high

I need the two panels removed and laid flat a couple of meters away from current location. Then return to site in one week and re install them. Both panels are 1.3 x 1.5m. One panel has a 25cm glass return. I can assist with lifting. - Due date: Before Friday, 20 October 2023

Render front besser block fence - Due date: Before Thursday, 19 October 2023

Build a timber picket fence approx 1.3m high, with single pedestrian gate centered with house, and double hinged vehicle gate to left side. Simple design. Total length is approx 8.5m (in place of temporary fencing in photo). Please offer best price including all materials. - Due date: Flexible

5x rusted fence posts (similar to colourbond) require repacement. Supply and install. Must have insurance and qbcc licence. - Due date: Flexible

I am needing to get my fence repaired or replaced, whichever is more cost effective. The problem is that the posts/footings have loosened on two sides. The side of the property which is approximately 20m from back gate to front corner and then about 15m from corner to front gate (road/front fence). Half a dozen of the palings also need to be replaced too (and stained if this service is offered). Thank you - Due date: Flexible

Remove and replace existing timber dividing fence of approx. 35m. The fence has hardwood sleepers at base also need replacing. Fence should be hardwood posts concreted into ground with pine pallings and rails. Please ensure you are insured and have appropriate licence to this work. - Due date: Flexible

Hi, Need someone to reattach wooden gate to fence, will require new hinges and screws as well.

We are looking for somebody to fix 2 sections of our fence, each roughly 8m long. Requires removal of old posts and replacing/re-posting (we think 5) then put it all back up. While we will replace posts with new lumbar, we'd like to keep the current fence palings and horizontal rails.