Find a fence installation professional in Gold Coast

Install Mesh Fencing Looking for someone experienced to install approximately 50m of mesh fencing along our backyard boundary in Tallebudgera. We have the mesh fencing and posts ready to go. Posts will need to be driven into firm ground approximately every 1.5m, with the mesh secured tightly, including along the bottom to prevent our dog escaping. We would like the fencing to go behind the plants slightly so it’s not an eye sore. No gate required. Existing fencing at both ends can potentially be used for securing. Our previously arranged installers cancelled last minute, so looking for someone available ASAP. Please only respond if you have fencing experience and the necessary tools.

I need someone to help install 3.2M of aluminium blade fencing (1.2m high) on an exisiting block base. I have all materials and fixings.

Replace and install 2 colourbond sheets on the fence panel We have already supplied the sheets, literally need to unbolt the top section of the fence panel, slip the old ones out and slip the new ones in Offer to take the old panels to the tip, or leave them there and send me a photo.

I have a 17m long colour bond fence to install. The base will consist of 2 x sleepers in a H post with a steel fence post bracket attached then the 1.8m high fence on top. The retaining part will be done by myself and an excavator is on site to lift the sleepers into place. Will be a days work for the right person.

I need 3x Pool gates installed to get the pool up to code

New colour bond fence to be installed including a gate., Approximately 4.4 m long in total and 1.8 m high. Ground has a moderate slope and panel would need to be cut to fit area against rock wall. Can supply all colour bond fencing and gate materials. Removal of old existing timber fence. Also to install one extra post to secure a power board to.

Supply and install 1.2m high aluminium pool-style fencing along both sides of the waterfront walkway, as marked in red in the photos. The old fence in the photo has been removed. Each side is approximately 2 metres long — around 4 metres total. Fence should be securely fixed to the existing timber deck The first section is 78cm, then change direction, 2m in total on one side, then another 2m on the other side.

Install fence Pool fence style between brickwork

Require Perspex on gate to be removed and a new piece of Perspex to be supplied and installed. The Perspex needs to be at least 2mm thick and cut to the following size: 73Wx 92H cm Note: AirTasker must provide all the tools and materials to complete the job. The price must be inclusive of materials. Valid Insurance is also required to work onsite.

I am needing a new colourbond fence and side gate supplied and installed to replace existing timber fence. Roughly 26m side fence and 9m back fence

looking to have this damaged outdoor metal gate replaced rather than repaired. I’d like someone experienced with metal gates/fencing to measure the opening, remove the existing damaged gate, supply or recommend a suitable replacement, and install it securely. Ideally I’d like the new gate to suit the existing railing/fence as closely as practical. Please let me know whether your offer is for labour only or includes the new gate/materials, and whether you can measure and source the replacement as part of the job. Photos attached.

I lattice free standing 240 x190 metres in front house lawn

Removal off old timber fence Supply and Installation of 35 lineal Mtrs of Colourbond 2100mm panels

Wanting a side gate approx 1.6m wide to secure the backyard for my duplex and secure the entrance to backyard for keeping a dog I will can pay for supplies seperately or also looking at ordering a custom made to be installed

Replacement motor for sliding gate

Install of 2 side fences (all products supplied by owner). Side fences to be affixed to front block fence. The front block fence is already completed and finished. Each side fence is 7.3m long fence lines 8 panels & 6 posts plus all the connecting parts are ready. Requires a qualified aluminium fence installer. Some cutting is required to fit correctly.

Looking for a reliable Tasker to install a colorbond fence, the area is around 10 meters long. Please get in touch with your availability and quote. Thanks!

Hello, I need someone to install a ~19.5m straight fence. Along a lake, concrete is already down. It will be 8 x2.4m panels (2 to be cut to size. 1x gate to be centred. All material ordered/paid for. Task to include collection from Burleigh Bunnings. To be collected/installed week commencing 07/08. Thank you.

Need someone to please purchase and install and outdoor door (to block walkway side of house) Shown in photo After white door with key lock example shown in photo. I’ve used AI to mock up the design

Will need an angle grinder to cut the 90mm x 90mm posts to size, and a rotary drill to screw posts into masonry wall. 40mm x 40mm Battens are cut to size already. All gate hardware and screws provided. It uses a rail and clip system similar to the first photo. From Eurowood. Also remove and dispose of existing gate. Estimate it will take one person 4 to 5 hours or 2 people 2 hours. Located Broadbeach Waters