Find local electrical rewiring electricians in VIC

I want new lights and wiring on my 8x5 trailer. Supply and install new lights with number plate light and rectangle plug.

Need someone to connect ornamental Christmas stars that were mounted to a ceiling to ornamental lights that can be connected to a PowerPoint There is some wiring there which is working and light globe but the cord is not long enough the cords need to be at least 3 meters each and it need the plug not a hard job but one that need doing

I have a 1950s-60s era vintage floor lamp that has had the power plug cut off it. I require a registered electrician to rewire the lamp, attach a new power plug and test that it’s operational and safe. Please note that I don’t have a replacement power plug but can buy one under your direction or you can provide it and this can be added to your Airtasker fee. Please only respond to this task if you’re a registered electrician, thanks!

Need a licensed electrician. Point has come loose and will need replacement. Also need the power point hardware to be supplied as well.

I have an old telephone that I want re-wired to connect to a landline socket. Wiring needs to follow Australian wiring standards and be safe. The converter I bought (see photos) works and I can receive calls but the phone is not making ring sound. The telephone needs 50 cycle telephone ring voltage to ring phone bell. Skills / Experience Required: • Licensed electrician or registered cabler (required in Australia for phone socket work)  • Experience with RJ-11 telephone wiring and older phone jacks / legacy phone plugs  • Knowledge of Australian phone wire colour coding and safe installation practices  • Ability to test for a dial tone and ensure the line is working after rewiring Location: Sunshine West

Need 10 lights installed , all points are pre wired or have batten lights 4 external wall lights 5 internal vanity wall lights 1 small pendant ceiling light

I need someone to help me to rewire an old chandelier and hang it up and connect it to the wires in the ceiling. Only electricians please.

Outdoor light rewired and outdoor sensor light installed

I’m reaching out to request a quotation for some electrical works at my apartment in Melbourne CBD. The scope of work includes: Rewiring and installing a new pendant light above the dining table (light fitting purchased from Beacon Lighting – see link attached below) Ensuring the lightbulb is dimmable Patching up the existing downlights in the same area There is carpark access available for vehicles under 2.2m in height within the building. Please let me know what information you might need from me to provide a quotation, as well as your earliest availability for the job. Beacon Lighting product link: https://www.beaconlighting.com.au/mfl-ballare-1-light-800mm-pendant-in-gypsum Thank you for your time, and I look forward to hearing from you. Kind regards, Justin

REPOST as I went away so post expired.. Let me know your quote. I have a floor lamp that the current cord is too short. I’d like the whole cable replaced with a new, longer cord (around 2 m) connected neatly into the lamp base. Please bring materials. Located in Heidelberg West. The more ASAP the better.

Need an electrician to rewire the fan so that it always has a power supply and can I control it with remote. There is a light and fan in the loft. If the switch is off then can't run the fan. If the switch is on can turn off the fan light but not the other light.

Outdoor fan - just needs a new remote rewired. We have the new remote. Just need to replace the receiving device in the fan. Low ceiling. In an alfresco area.

You just need to rewire the live wires to the switch board as it’s incomplete, that turn on the chandalier, downlights, and outside light, so 3 switches total, should be a 10 minute job, I have other work I may need done if price is good, 2 floodlights and a wall mirror mounted

Wires burned out attached to the ignition switch in a 1938 Plymouth. Coil and ignition switch are working but an electrical fault like a short circuit or loose connection caused the insulation to burn off two or three wires attached to the ignition switch. One wire bring power from the ammeter a second connects to the fuel gauge and the third connected to a starter button on the dash.

Rewiring for a one bedroom apartment, replace light switches and power points.

rewire house, metre fuses etc. also / or few small jobs

Electrical Re-wire - Power circuit 2 of them Full rewiring of power circuit to meet current electrical regulations Disconnect all wiring that is non-compliant or faulty. Re-wire all powerpoints that are non-compliant or faulty Replace all double GPOs with new double GPOs

Disconnect and remove existing power to allow for ceiling works. Supply and install downlights. 4x Supply and install a side flood light 1x Supply and install a front wall light 1x Supply and install outlets. 4x (general power and garage door power) Supply and install a power outlet for the outdoor water pump to connect from the rainwater tank (pump by others). 1x Supply and install light switches.

looking for a electrician to rewire a house light. Down light has blown for my front door, looks like it was spliced into the main wire when originally installed. looking for an electrician to replace the light or modify the connection for a plug. already have the replacement light in hand, just need the wiring done.

I have two vintage wall sconces that need repairs. One seems to have the wiring already and a switch, the other has no wiring and no cord/switch at all