Find a local console repairer in VIC

Like-for-like replacement of kitchen sink (already fitted in bench top), mixer tap, and undersink hot water unit. All existing services in place — hot and cold water supply, waste connection, and dedicated GPO are already installed and functional. Supplying own fixtures (tap, sink, SHC 15). Wanting job completed Sunday or Monday.

The fridge has been off for about 6 months and turning it back on the fridge is now freezing. I have reset the electronic temp setting turned on and off Cleaned the vents Adjusted the min max temp Set the fridge to defrost The fridge is located at Tony sheumack theatre in Berwick. I do not have access until 6pm

They’re very accessible but I have no spring compressors or motivation to touch the big ball of energy Looking for front bump stops replaced on a 2008 territory before the 21st Bump stops supplied and top mounts if they’re too worn to be reused

Scope of Works Remove and dispose of existing deteriorated sleeper steps Excavate as required to allow for new stepped formation and correct levels Supply and install new treated pine sleeper steps Install structural corner and end posts, set in concrete, to retain and secure sleeper tiers Backfill and compact to ensure stability and longevity

We want to install 32 speed humps which will make upto 8meter. And also want to install 11 parking wheel stops. We have fixings also. And these needs to be fixed into the concerete floor.

Hello I am looking for a plumber. Need to swap 2 taps, from kitchen to laundry.

Tap is leaking Straight forward job

I have a kitchen tap that requires removal of the current tap and install of a new tap (which I will supply) I have a bathroom basin tap set that requires removal of the current tap and install of a new basin tap set (which I will supply) I have a shower hot and cold tap that requires removal and install of new taps (which I will supply). Current shower head to remain

Basin taps in the bathroom are leaking. These need to be fixed.

Blocked drain outside the back property. Need portable high pressure jetting machine

This RCD trips intermittently on one circuit (bedrooms/living). Can you check leakage and replace RCD if needed?”

I am looking for someone to remove 15 Pittosporum hedge stumps from my property. The hedges have already been cut down to ground level, so the task is strictly for the removal of the stumps and root systems only. No foliage or branch disposal is required. Quantity: 15 stumps. Stump Size: Approximately 130-200mm each. Soil: Silty sand for mininum 70cm deep and silty clay underneath. Access: Easy access via driveway width up to 2000mm. Height clearance of 2.5m due to carport. Requirements: You must provide your own equipment (stump grinder or excavator). Disposal: Not required, mulch will be left on site. No underground utilities under or near the stumps. Garden bed will be removed before the job.

We have a wasps nest in our courtyard that needs to be removed or exterminated. As far as we can tell, it is inside a pole at the top of the courtyard wall.

There are few holes in ceiling that need covering up and just one hole on wall that needs patching up ready for paint will only need Battons or timbers 4hrs 400

I have removed the trees, now looking to remove 6 tree stumps 3 have been cut at ground level, 2 others 40-50cm stumps and 1 at 1.5 metres. Due to shoulder reconstruction I can cut others to ground level but will require a few weeks before completing

Hi there I'm looking for a qualified locksmith / carpenter to install a Philips EasyKey DDL608-5HWS Slim Smart Fingerprint Door Lock on my from door. I have the hardware itself. I attach photos of the existing door and lock in case that assists. Thank you

Hello I need two taps that have come loose to be tightened/reinstalled

Looking for someone experienced with timber floor repairs to fix a few small chips/gouges in our wooden floorboards. Damage includes: -A couple of small holes/chips in the wood -some surface wear/scratches in nearby area I’m not looking for a full sand/polish at this stage — just a tidy cosmetic repair (fill, colour match, and seal if needed) to make the damage less noticeable. Please bring your own tools/materials and have experience with timber floor patch repairs. Photos attached.

I have 2 sections of gutter that have come loose from the fascia (clips/brackets have come off) and one corner joiner has broken, so the gutter is slightly hanging. Looking for someone to: • Reattach/replace gutter clips • Replace or reseal the corner joiner • Ensure gutter is secure and aligned properly Single storey house, easy access. Job is straightforward – should be quick for someone experienced.

Need 4 small pencil pine tree stumps grinded to below ground level.