Find an experienced chair repair pro in QLD

We are looking to have a wheelchair ramp fabricated for front and rear door. doesn't have to be fancy wooden preferred. will supply all materials needed.

Paint outdoor bar table (150cm x 80cm) and 4x stools. Basic design. Paint required. Will pay for paint additional to the job fee, being a metal material would need an appropriate paint.

Would like someone to help build a family rocking chair, which is also like an arm chair with a recliner. I have attached an image of something SIMILAR* (not the exact one)

Massage chair stop working. Have receive a new Motherboard and tried rewiring. Still not working. Manufacture has said to get a technician in to look at it and quote how much to fix.

Hi I need someone to come pick up a bed, desk, office chair and set of draws and take it to the dump

RAMNEFJÄLL upholstered bed frame 5 x INGOLF chair DANDERYD dining table

We have 4 sturdy white outdoor wooden chairs (Adirondacks) Paint usually lasts 4-5 years before requiring new coats. Seeking someone with good painting skills. Requirement: Sand as appropriate (can leave old coats on where they are solid - no need to strip paint back to bare timber!) Apply a coat of gloss based white paint (likely oil or enamel). Then sand lightly and apply a second, final coat. We can supply paint. The 4 Chairs can be painted undercover at our home or if close by, perhaps taken off site and painted.

6 metal outdoor chairs where the plastic rattan coverings are cracked and breaking. All 6 chairs require attention. Loose and broken pieces need to be removed and replaced with new plastic.

Take away and dump wardrobe, drawers and cupboard and 4 x recliner chairs (refer photos- cat not included)

We have 6 stand up desks, chairs and computer monitors that need to be assembled from the box and rubbish taken away

2x flat pack sun lounges delivered chasing someone to put together as I don’t have time

Needing front caster wheel bearing on wheelchair replaced. I have the parts

Put together a toddler’s cot (will require a drill), a toddler highchair and a toddler table and chairs. The table and chairs are screw together so it’s simple.

Two timber chairs to have screws replaced and bolted back in so they are back to being sturdy and stable

Clean deck 8 dining chairs & slats

The table is teak, purchased in 2022 from Eureka Furniture. It is a 2.3m long x 1m wide table. I had it oiled by a painter, he had recommended using Cabot’s CFP Floor interior on it. At the time I didn’t realise this wasn’t suitable for outdoor furniture. I moved house and the outdoor area is smaller and not so protected. Due to the weather event my table top and legs have gone mouldy as it got extremely wet. Could I please book to have the whole table sanded back and redone? I have already purchased furniture oil. Likely will also need to the 6 chairs redone, these are not mouldy, but I would like the colours to match. Happy to pay for labour and supplies.

I'm looking for a handyman who can adjust and shave some wood to ensure both of my trays fit my chair properly. The height of my armrests is approximately 2 cm, while the wood on one tray is 3 cm thick, making it difficult for the clamps to hold. The combined width of the two armrests and my seat is about 64 cm, and the wood on the other tray also needs to be shaved slightly to fit.

Have a replacement gas lift and need it installed to office chair.

Assemble kids high chair

10 salon chair bases need replacing, The top of the chairs need to be taken off to put the new bases on, they are quite screwed in and will need to be hammered out to put the new bases in. We require 2 people