Find a professional local car service in NSW

Mazda 6 (2006) Center console/display completely losing power (display, lights & controls go blank and unresponsive). A/C if on, will continue to work. Occurs most often when weather (or car interior is warm/hot). Randomly restore function (during drive or when temperature lowers). Images included: display off (car on) display on (car on) When quoting: Please let me know what I'm up (eg, replacement center unit, complete disassemble for rewiring or re-soldering joints) Approximate cost If you can come to me or I need to come to you Length of time required to complete

Kenwood 8 inch Active subwoofer to be installed under seat in Holden Rodeo. Have aftermarket head unit in car

Knocked mirror whilst reversing . Think whole of passenger side mirror needs replacing. Not sure if electric or not.

Need pink slip done, cheers

Tyre change for Ford Everest in North Avoca. Nail in tyre. Back left tyre. Easy access to car.

My bmw was overheated once and when i checked water in radiator was boiling and there was milky yellow substance light not thick and engine oil was clean so I need someone to fix it

Hi, I'm after a quote to have two black vinyl stripes put down the bonnet of my Mini. Could you let me know the cost and your next available time? Happy to send photos of the car. Thanks!

Need to replace mazda 6 2007 Headlight for both right and left

My 2011 Hyundai i30 won’t start, likely due to a flat battery. Need someone to come out, jump-start it and test the battery to see if it needs replacing. Please bring necessary equipment.

Hi have purchased an Oricon uhf radio and I would like it installed on my Ute, Ford ranger 2019 model, there is no bull bar on the Ute but I’d like it installed on a bonnet hinge mount. Located in Riverstone

Repair minor dent in car door

Pre-Purchase Mechanical Inspection – 2014 MINI Cooper S Paceman Looking for a qualified, experienced mobile mechanic to conduct a comprehensive pre-purchase inspection of a 2014 MINI Cooper S Paceman automatic with approximately 201,000 km. Location: Pymble, NSW The vehicle has recently had approximately $4,150 worth of repairs, including suspension components, oil seals, thermostat housing and engine mount. I'd like the inspection to cover: Engine condition, timing chain and turbocharger Automatic transmission Oil and coolant leaks Cooling system and previous repairs Full diagnostic fault-code scan Suspension, brakes, tyres and underbody Evidence of accident damage Panoramic sunroof operation Test drive, subject to seller approval Please provide a written report with photos, estimated costs of any necessary repairs and your recommendation on whether the car is a sound purchase. Experience with MINI/BMW vehicles is strongly preferred. Please confirm your qualifications, diagnostic equipment and what's included in your quote. Budget: $200, negotiable depending on experience and inspection scope.

Need help replacing a windshield wiper motor in my 2008 Toyota Yaris hatchback I can find the part or if you can source it that’d be great. Car is parked in Redfern but I can also bring it to you

Install my new XTM 270 awning to my Nissan elgrand camper van. Roof racks already in place and am upgrading from the kings awning already in place on van which will be removed

Need someone with jumper park or leads to start Ford Ranger after lights were left on

We’re looking to buy a Ford Ranger based in George’s Hall and would like the mechanic to check it over before we purchase

My 2012 Subaru Tribeca is throwing OBD2 codes P0700 and P1710 (Turbine Speed Sensor #2 circuit malfunction). The car is driving normally and temperature is fine, but the check engine light and flashing cruise control are on. ​Looking for a qualified mechanic or mobile mechanic to inspect the wiring/sensor. I am looking for someone open to checking/replacing just the turbine speed sensor rather than quoting for a full transmission valve body replacement. Located in Quakers Hill.

Respray needed for Bonnet & Roof only, currently sun damaged with clear coat failure and paint oxidation. Looking for a tidy up job. Last post was taken down.

I have brought a brand new 02 sensor for my bmw 2009 320i as it needs a new one. I’m in need of someone who can come replace the old one with the new one and delete the check engine code. My partner has called multiple mechanics but none will do it unless we reorder the 02 sensor from them or they’re charging way more then what we can afford. We brought our own as we did have someone who said they could come help us and do it as they’ve done it before but they’ve just completely been ignoring me and my partner for weeks now. We’ve got children and really need to get this car up and going and the 02 sensor is the only thing we need to do before we can get it registered. I’ll put a cost here but obviously I am not car smart like my partner so please submit a reasonable price offer that isn’t going to cost a arm and a leg as stated we have children and we don’t want to be having to pay more then we can afford. Thank you

I have the new button and have half started the job. Just can't seem to remove the harness plug from the old switch. Need someone who has done this before to unplug and finish