Find a local excavator service near you

A leaking pipe carrying bore retic water, already dig up, photo attached

Remove a block of cabinet (2 doors opening towards each other) as it’s not used and is too low for the fridge. Paint/process the exposed surfaces where needed. Bore round holes in the cabinet walls from the fridge to the sinks for running the water pipe at back of fridge.

Need bore water motor repair/ replacement including any plumbing work

Hi, I would like to drill a bore to create a water source on my land. Please provide quotes for drilling, adding piping and filter (dependant on water quality). Just getting quotes for now as I still need to clear the land first

Hi I have recently installed a bore for my lawn and need someone to connect it to retic and install a tap for bore water. Distance between bore and retic is around 5 feet

Retic service and maintenance, mainly replacing broken heads. One water leak, pipe not very deep, Bore water in use.

I need a electrician to check our centrifugal bore power connection

Irrigation set up to my home

I have already got a bore and wants to add up a tap on it

I have already got a bore and wants to add up a tap on it

Move, dig and bury bore water pipe - currently sticking out and looks terrible

Water boring for my backyard.

Ideally you have a chainsaw. Looking to remove some impacted branches to assess the extent and to see if the remainder of the plant can be saved. Type of gardening: Other Size of garden: Under 50m² Has green waste bin: Yes

I want my switch board changed , I am planning for Solor and Bathhery Installation . Currently having issues in the kitchen if I have toaster and kettle on , it trips for fuse

Replace or repair leaking valve on garden bore

We have an old bore pump which is broken. We are looking for the installation of a new pump.

I want to run an irrigation line on the other side of my driveway where there’s no water, the distance to to dig under is about 4 m. I want to run a 25 mm water pipe.

The bore water pump starts and runs for about 5–10 seconds but no water comes out, and it then automatically shuts off.

I need about 40 or so holes dug for posts for a retaining wall. They should be the standard size for a post of 300mm diameter and will range between 200 and 1000mm deep. Too many and some too deep to do by hand.

Looking for someone who can properly install the follwing - Blinds x3 (above a step or two ladder high) not too high up - Door lock (smart door lock) - if this can’t be done that’s fine - Alexa echo and skylight mounted to wall 15” - Dyson mount drilled into wall