Find a reliable appliance technician in Preston Lower

Element blown after a power surge. Euro oven

Carry out Gas Compliance Safety Check and issue Certificate. Multiple Units Location Preston, Fitzroy & Windsor

LG washing machine no longer needed moving out and need it gone

Fisher & payke RF S22ADX5 fridge sensor continually beeping but nothing is blocking doorway

Need to connect my washing machine (may need to provide a hose, I have one from my old house) and my oven in my new place It’s a new build and I’ve just moved in and have no clue how to get the oven working It’s never been switched on before

I bought a secondhand ASKO D5896XXL fully embedded dishwasher. It seemed to run ok on its first cycle, but is now unresponsive. From what I understand, it is a drainage fault. Besides the on/off button, the rest of the buttons do not do anything (when its in this state). There is no way to do a hard reset. Turning it offer, unplugging it, any sequence of key pressing does not do anything. I siphoned it out and eventually it reset. I successfully did a short rinse cycle with the drainage going into a bucket, then I reconnected everything and it threw the same fault. Now it is stuck back in that non-responsive mode. I've cleaned everything I can access. I'm hoping it was something as simple as the drainage hose placement, so I'll try that when it's back online. But failing that, I need to call in the big guns (i.e. you). Looking for someone to come get it working :)

My esatto washing machine keeps coming up with E4. I would love for it to be fixed as it’s a good washer otherwise. The drum can’t detect the weight and it keeps refilling or stoping and shakes terribly with minimum things in it. Please help

Front loader washing machine - The wire ring washer that holds the rubber seal in place has popped off I just need someone to put it back on with a tool. Quick job.

I need my new washing machine connected. The P-trap needs a hole drilled into the plastic where the water discharge nozzle is located, along with the other hot and cold connection to be attached.

The Ice machine brand name Hoshizaki started to make a loud squealing sound and screen displayed "E1" error code and stopped making Ice

My washer/dryer machine, a Samsung WD0754W8E, is draining water into the drum, even on a dry cycle. I've drained water and cleaned the filter several times, and yet it continues to drain water into the drum even when on a drying cycle. The 'SE' error flashes on the screen as well. I'm looking for someone to fix this

Disconnect existing gas stove and plumbing in new stove. May need longer hose to get from existing gas point on new stove to the penetration in floor boards.

Dryer is just out of warranty and doesn't dry clothes at all. It's stopped collecting water and takes days to dry anything

I need two Ring cameras affixed to my walls. 1) is a doorbell camera to be placed outside the front door and the other 2) is an outdoor camera to be affixed next to my garage door. This one will be on brick.

Dishwasher drawer has come loose from cupboard drawer, needs to be reattached..

Need wood/gas oven pilot fix. Preferably someone near Preston

Service diesel heater on Mercedes Benz sprinter van showing error code 8 - showing lack of fuel. Have been told it’s likely fuel filter needs cleaning as was non operational for 9 months

I'm looking for an electrician with deep knowledge of how induction cooktops work to provide advice and recommendation of a possibly faulty induction cooktop.

Need Help Moving Washing Machine & Setting Up TV Looking for two (I assume, given tv) strong and practical people to: - Move a washing machine from the garage into the laundry (a few steps involved) and connect it to taps/drainage Unbox and set up a 65-inch Samsung Serif TV (48kg – two-person lift), including screwing on the legs and positioning it (no wall mounting) Trolley required. No rubbish removal needed. Should be a quick job for someone experienced. Located in West Preston on Gilbert Road

ongoing tripping problem in my shop kitchen when we plug in the two door upright fridge, the whole kitchen trips off. Tried to move the connection to another power point but still trips off. looks like the whole kitchen load is running from one load and its too much. Need to inspect the capacity of the power in the kitchen and find solution