Find a reliable appliance technician in Floreat

My sunbeam Torino steam wand blocked after I cleaned it. It needs to be opened and the blockage removed.

Karcher K5 not turning on. Was working fine and then cut out and havent been able to get it running again.

The dishwasher is about 5 uears old. The water isnt heating and getting e9 error

Replace electrical cord on a GHD hair straightener

The igniter on my old electrolux bbq is not work. I need it replaced/fixed. Must supply any parts required as well as all tools. Note, this is not just a battery replacement

We have a Miele fridge and the top section is not staying cold, the temperature gauge says it’s colder than it is. Freezer is fine.

Samsung front loader not draining. Have manually drained and cleared drain filter twice and still not working.

I need a handy person to help install a new rangehood vent on an exterior brick wall. The existing round hole is a bit too small for the new vent’s spigot, so you’ll need to carefully enlarge the brick opening (just a few millimetres). I’ve already removed the old vent and have the new vent, wall plugs and screws ready to go. The job involves: * Enlarging the existing circular hole in the brickwork so the new vent fits snugly * Sliding the vent’s spigot into the duct and securing the duct * Mounting the vent flange to the wall using masonry screws and plugs * Sealing the duct connection with foil tape and finishing with exterior silicone for a weather‑tight seal * Cleaning up afterwards Materials: I will provide the vent, plugs and screws; please bring foil tape and any tools needed to enlarge the hole (e.g. masonry drill, chisel, grinder) and finish the job. Experience with brickwork and vent installations preferred.

I need an experienced installer to remove an existing integrated dishwasher and install a new Bosch fully integrated dishwasher. The current dishwasher (ASKO) was poorly installed and appears to have been forced into the cavity, causing damage to the cabinet panel and adjacent cupboard. The original dishwasher (Miele) previously fit correctly, so the space should work with proper alignment. ⚠️ This is not a standard swap job. Scope of work: * Carefully remove existing integrated dishwasher (tight fit) * Install new Bosch fully integrated dishwasher (already delivered) * Attach and align existing cabinet door panel * Level and centre appliance properly * Ensure even spacing on both sides * Ensure door opens fully without rubbing cabinet * Do NOT force unit into cavity ⸻ Important (corner installation): This is a corner position, so door clearance and spacing are critical. A small adjustment (e.g. 10–15mm filler strip or repositioning) may be required to allow proper fit. ⸻ Looking for someone who: * Has experience with integrated dishwashers (not just freestanding) * Understands cabinet alignment and spacing * Is comfortable making minor cabinetry adjustments if needed Please confirm your experience with integrated installs when quoting.

Disconnect two pipes from my washing machine to the taps so the machine can be moved. I don’t need you to move the machine, just disconnect it!

I have a Bosch stacking kit that I would like installed between my washing machine and dryer. Currently have a Bosch heat pump dryer stacker directly on top of washing machine that will need to be lifted down to do the job and then back up on top after shelf installation. Dryer very heavy and will likely need 2 people to move. Looking to have this done sometime on 14-17 April before 2pm.

The water pump to an internal water feature has stopped working. I have purchased a new pump which I need fitted. This will also require removal and reinstallation of a new electrical plug to the water pump.

Fix two in-built outdoor gas heaters in alfresco area. Heater 1: No ‘click’/sparking to ignite Heater 2: Stays on for around an hour then turns off and doesn’t come back on again. We’ll discuss price in the chat

Dishwasher stopped working. Just making a noise.

I have had a dishwasher delivered and it's free standing, I need it installed and the old one removed

Hi I need a pizza oven moved from Floreat to Halls Head. It’s on a slab 950 x 1050 total weight is around 500kg.

See previous details above

We need the gas supply changed to match the blue line in the image, so that we can complete the limestone wall.

My Sportop E450 home ellyptical is making a clunking noise from one side when I use it. Would like it inspected and serviced. If repair required involving replacement parts, we can discuss and address as separate scope

Licensed plumber required to cut into copper pipe below sink, fit pre-bought T-connector and connect to new dishwasher hose