Hire a trusted appliance repair service in Sydney Northern Beaches

Dishwasher door is falling hard when opening - spring mechanism needs reattaching? Just a standard LG dishwasher

Look over the wiring and hoses on my 10 year old Breville dual boiler to find any problems, fix problems if any are found

Dishwasher isn’t draining. See photos - have removed and cleaned the filter but the sump underneath is collecting water that won’t drain.

The throttle of the victa lawnmower needs to be replaced as the throttle is broken . I would also like the lawnmower blades replaced

We have a line running from the ice maker to the taps but it’s not working , we have just moved in. We need it either fixing or replacing. If replacing it’s approx 10 metre line. Tried the taps and reset but doesn’t seem to be pulling through to the ice maker. Ideally need fixing today AM

I changed the orientation of the fridge door so it opened the opposite way to previously and now the door thinks it’s open. The sensor beeps 3 times every 30seconds-1 minute to say the door is open but it isn’t. The light also is not on.

The 2 appliances are: 1) F&P DishDrawer which occasionally leaks, has pooling water, does not clean well and the seals inside look deteriorated; 2) Westinghouse gas oven which does not reliably ignite when turning on.

Hi. Treadmill stopped working for reasons unknown. Need quote to see if it can be repaired and is it worth it So for now need quote to come to frenchs forest to look at it only and tell us cost to repair Thanks

The dishwasher is dripping from the very bottom (right hand side). Gasket appears okay.

The self closing drawer in the kitchen does not close by itself anymore I need it fuxed

Range hood cabinet has fallen off.

The machine requires the start button to be held down continuously to run, and has now stopped starting altogether. Could this indicate an electrical fault?"

Replace broken door seal / gasket on Beko washing machine. We have the genuine part in hand.

The upper spray arm has broken off and needs to be replaced.

Brewing and steam wand stopped after a few seconds. Problems persists after descale and steam wand cleaning. Onsite or drop off repair acceptable. Price exclude parts if required.

F 70 repairs on Miele dishwasher

I need someone to look at my Asko dishwasher. It hasn't been used for 1 month and now I'm getting an error message - water inlet fault F12. Probably something really simple

Hi, I’m looking for an experienced technician to inspect and repair a Hobart H50 SU commercial dishwasher in our café. Issue: * The dishwasher was working fine previously. * The drain cycle works normally and drains the water without any issues. * However, during the wash cycle, the water level keeps rising until it overflows from the overflow/air gap. * I’m not sure whether it’s a water level sensor, inlet valve, or another issue. Looking for someone with experience repairing commercial Hobart dishwashers. Please let me know: . * Your availability (preferably today or tomorrow morning)

Washer not working sounds like it’s got something stuck - can’t get screw off to drain it Clear and check it

The motor is running but the latch to bring the roller back up has come off. This has happened before.