Hire a trusted appliance repair service in Bondi

Our fridge/freezer is making a constant very loud noise and producing a lot of ice. We have defrosted it and removed all the ice but the noise is getting worse. The noise seems to stop when the door is open but otherwise is constant. Brand: Fisher & Paykel

My AEG Favorit dishwasher is showing error code i10 (water inlet fault) and stops after about 30 seconds of running. Through troubleshooting I’ve identified the likely cause as a faulty or triggered Aquastop solenoid valve (Type ES-1, 220-240V, 50-60 Hz, 8VA, 0.2-10 bar) which sits between the water supply and the dishwasher inlet hose under the sink. The water supply tap is confirmed open and working. The machine powers on and starts a cycle but cuts out with the i10 error. Looking for someone experienced with AEG/Electrolux dishwasher repairs who can diagnose and replace the Aquastop valve if needed. The dishwasher is a freestanding model in Sydney.

Oven handle door and bedroom drawers broken. Need repair.

Replace broke door hinge on Meile microwave oven. I have the part. just need someone to professionally install

Looking for a repair for my Hisense washing machine which has stopped spinning and just beeps!

Our dryer is spitting out water out of a pipe at the back. We have a Bosch dryer brought off marketplace so we think they may either be a pipe missing, or something is blocked.

Smeg integrated dishwasher (older model, EST3605) not completing wash cycle properly. Issue: machine powers on, starts normally, drains correctly at the beginning of the cycle, and makes the usual startup sounds for the first 2–3 minutes, but then seems to stop early and doesn’t continue through the full wash cycle or properly wash dishes. No obvious blockage visible and drainage appears to be working. Looking for someone to attend site, diagnose the issue, and ideally carry out a straightforward repair on the spot if possible. Located in Bondi Thanks!

Samsung SR318LSTC, fridge not working. The freezer is still operating however the coils at the back of the fridge don’t stay cold. It may be a faulty sensor as the coils do go cold once the temperature of the fridge rises and then turns off.

Our washing machine is running through the full cycle but stops right at the final drain stage and turns off. We then have to manually drain the pipe from the front to empty it. We suspect there may be a blockage in the drain pipe. We’re not sure on pricing for this kind of repair, so please send through your quote. Machine details: Siemens i-Dos iQ 800 What we’ve already tried: • Cleaned the filter • Ran a cleaning cycle Location: Bondi (apartment) Availability: • Anytime after 1pm today • Or before 11:30am tomorrow Thanks so much!

Fix leaky attachment to washing machine

My Samsung fridge is leaking water out at the bottom onto the ground. Ice sheets also keep forming on the floor of the freezer section. Need fixing please.

Agitator came off. I have a new one but the screw seems to be stuck

Samsung fridge/freezer temperature broken

Fisher & Payel dryer door has come off, need someone that can help replace with door. Even better if person has the parts.

My recliner is making crunching noises when I extend the chair and comes from the seat.

My Electrolux front loader washing machine was purchased in 2013. It still turns on and runs cycles however clothes are coming out dirtier/damper than usual - may need a filter clean or change.

My Onix front-load washing machine stopped filling with water. Filter clean, tap is on and hose seems ok — likely inlet valve. Need someone to diagnose and replace the faulty valve if needed. I do not have a replacement valve. Thanks!

Description: Hi! I need help with my DoorWorks 800N garage door opener. I currently have two remotes – one works fine, but the other one has stopped working. I already tried changing the battery, but it didn’t help. I also tried to reset and reprogram it, but couldn’t get it to work properly. I’d like someone to: • Check and troubleshoot the current remotes • Order a compatible new remote (if needed) • Program/sync the new remote(s) to the opener • Make sure everything is working smoothly The opener is mounted in the garage ceiling, easily accessible. Please bring any tools or equipment needed. Looking for someone experienced with garage door openers, especially DoorWorks models.

My dryer motor seems to have stopped, it won't start spinning, need some help to fix it

Hi there! I have a Smeg gas stove. When connected to power, all ignition switches constantly click What I need: - Qualified technician to visit my home - Diagnose the ignition problem - Repair the issue - Bring necessary tools and possible replacement parts for Smeg stoves