Hire a trusted appliance repair service in Alexandria

there's a loose wire in my range hood that prevents the lights from always working.

My washing machine wasn’t shutting properly today and I’ve realised it’s to do with the seal not being in properly. The metal ring inside the seal was coming out and I couldn’t get it back in properly. If I take the metal ring out I can get the seal to properly seal and the machine works but I’m worried to use it without the metal ring inside. I’ve got the metal ring back in now but when that’s in I can’t get the seal on properly. It seems like a simple fix I just can’t seem to do it.

‘Electrolux Chef’ oven door hinge is broken and door comes off. Assess and source & install replacement oven door hinge. The oven is Electrolux 'chef' oven, serial number 210 41024, Model CFE535WB. Research suggests that both hinges need to be replaced despite only one being broken so please factor that in to your quote. I see there is a $25 hinge available from Statewide Appliance Spares which should work. To be done before 5:30pm any day, not available Saturdays. Unit is on botany road Alexandria, near Waterloo metro station. Ground floor unit, some street parking nearby but no complex parking.

Please fix the thermostat in Kitchen aid espresso machine

Delonghi automatic coffee machine, someone put beans in the wrong hole (the one in the middle) and the machine stopped working. It comes up with triangle image for error and the motor behind the water unit looks like it's popped out Need repair ASAP Ideally Wednesday 21 morning. Located in office, alexandria 2015

I need someone to replace a part of the motor of this fan. If required, a new motor can be purchased at my expense.

Our front end loader was playing up for a few days, unable to take a full load, then the drum stopped turning altogether. It is a front end loader F&P (10kg) and about 8 years old (I think..). It has always worked well until know. The next page asks for an demands a budget... I can't answer that until I know what the problem is :(

Dishwasher is Fischer & Paykel and has FCO error. Cannot get it to drain.

Bosch Maxx classic has stopped running. Looking for someone to fix it. The washing machine turns on, starts running but doesn't spin and stops intermittently.

I have a Kogan 8kg Front Load Washing Machine which appears to be having issues with water intake (that is a layman guess). Just moved to a new place and am keen to get it sorted ASAP

The dishwasher cleans but fails to dry. It appears all filters and drains are clear, suspect it is an electrical issue. Model is Bosch Supersilence Model number is SMU68M25AU/B3 Looking for a handyman to diagnose and repair if worthwhile.

Our gas heater turns on and runs, but then shuts off after a few minutes. If you wait a while, it can be turned back on, but then after running for a few minutes, it will shut off again. The bottle is full.

Looking for an experienced fridge technician to inspect and repair my fridge. It started beeping non-stop even though the door was closed. After two days it stopped beeping, but when it did, it also tripped the power to the kitchen. Power was restored, but now the fridge doesn’t turn on at all, even when plugged into other PowerPoints. A licensed sparky has checked the cord and confirmed power is reaching the fridge — the issue seems to be internal. Ideally looking for someone who can: • Diagnose the fault • Repair or replace the faulty component (control board, fuse, sensor etc.) • Let me know if it’s beyond saving

Electrolux ultimate 700, spin cycle doesn’t complete and shuts down

There is an issue with washing machine showing error code F-03. We have cleaned the drainage filter at the front twice, pulled out the machine and checked the drain hose at the back for any obvious signs of blockage and also checked for any signs of blockage in the door and inside the drum. Tried resetting it as well and seems like the it is still the same issue. Diagnosis and repair needed. Will pay for any parts required.

It's an old Bosch dishwasher (SMU24AS00E/68). The power turns on, but it no longer operates.

Dryer isnt heating and moving

The grooming table motor is receiving power and engaging (you can hear it running when the control is activated), but the table itself is not raising or lowering. It seems the drive mechanism may be jammed or something else—possibly an issue with the actuator, lift arm, or internal linkage. The motor runs but there's no movement at all, suggesting a mechanical fault rather than an electrical one. Please send us your cost. Thank you!

Help fix dishwasher (showing pump related error)

The refrigerator is not cooling but the freezer is working fine