Hire a professional washing machine repair service in Inner South Melbourne

Just fix the rubber of the washing machine

Install Asko washing machine and dryer onto new wall bracket in laundry , take off storage box

Install Asko washing machine plus hang dryer install bracket above w machine and attach to water pipes

Warning machine was not connected properly by removalists and was leaking. This is an urgent but quick fix - just can’t do it by myself - tried and water went everywhere! Need someone here ASAP - like now.

Need an experienced technician or appliance repairer to replace the torn rubber door boot seal/gasket on my Bosch Series 4 Front Load Washing Machine. The Issue: Rubber door seal is torn/damaged near the bottom lip (causing leaks). Task Required: Supply (or install) new genuine Bosch replacement gasket, remove old seal/spring clamps, clean lip area, and fit new gasket securely. Machine: Bosch Series 4 Front Loader. Note: Please indicate in your offer if your quote includes supplying the replacement part or if I need to purchase the seal separately!

Hi there, I have a Bosch Serie 6 Wash & Dry washer-dryer, model WVH28441AU/01. The front door boot seal is torn and leaking out the front of the machine.

Washing machine door jammed. Need someone to just jam it open.

We are moving to a new house and need to have our washing machine and dryer connected. The dryer has a pipe connected for the water.

Require a handy person to remove a door, install a washing machine and then install the door again. Most of the hinges are off the door just one holding it in place.

Hi takers, I need help replacing the rubber seal on my washing machine. I have the part ready to go. See pic for washing machine. Electrolux 7.5 EWF725DQWA

I think there’s a block in Washing machine

My Fisher and Paykel washing machine stops during the rinse cycle with a “clear filter” error. I have cleaned the filter and there is nothing stuck in it but the error comes back after I resume the cycle. Need someone to fix the problem. Model WH7560J3

We've recently moved into a new property and need help reconnecting our washing machine. The AquaStop inlet hose was originally connected to the hot water tap. We attempted to move it to the cold water tap ourselves, but access is difficult due to a large water pipe obstructing the connection. As a result, the hose is currently disconnected and not connected to either tap. We're looking for someone who can reconnect the AquaStop hose to the cold water tap and check that everything is set up correctly. The washing machine is already in position and I have attached photos for reference. No new parts should be required, I’m hoping for a simple reconnection rather than a full plumbing call out.

Help me untwist the hose from tab

Our tenant used the washing machine and a bar underwire is now stuck under the drum

I need a plumber to replace my kitchen sink tap (tap supplied) and connect my washing machine drain hose extension (supplied for you too) to existing under-sink plumbing. All plumbing points already in place. Straightforward apartment job.

Hello! When I moved in, the washing machine was connected to the hot water tap. I need it switched to the cold water tap please. The connection is just too tight for me to unscrew myself.

Need a tap changed in laundry sink and washing machine stoppers changed

I need someone to drill a neat access hole in the side panel of my laundry cabinet so the washing machine inlet hose can pass through to the water tap located in the adjacent metal cupboard. Please also fit a white plastic grommet for a tidy finish if available. I gave it a go before realising my drill bits were for wood only 🤦🏻‍♂️

Our LG washing machine started leaking after we moved house. Hoping to get someone to look at it and tell us what is wrong. Hopefully it is a quick fix, but if not and it was damaged in transport to our new house, insurance from the move will hopefully cover it.