Find a reliable appliance technician in South Brisbane

Need someone qualified to install a new gas / electric oven.

Stop a Thompson bandsaw from screeching when blade stops

need the get the rangehood installed with exhaust section to be completed

I have the replacement seal and part, but need help taking old broken seal out and fitting the new one in place. It’s a Samsung machine

Move out old washing machine, get other out of the garage and install Don’t need to dispose of anything

Need gas fitter to provide gas system compliance certificate for LPG company.

From my analysis of the noise, it seems that the air damper assembly on my LG GB‑455PL refrigerator needs to be replaced. I understand this is a DIY job with no need to access electrical components. I understand it’s quite a quick task to replace with a new one (less than an hour)

• connect gas to fryer • check the existing gas connection of the stove and grill to ensure functionality

I require a hot water tap above the washing machine , currently only cold. Copper lines behind or above to connect to, sink with hot & cold next to it

Looking for a plumber/gas fitter to replace my gas regulator with one provided. You will need to supply required fittings/adaptors to get it to work.

Looking for an experienced technician to inspect and repair an automatic external sliding door at a residential property. Issue details: Automatic sliding external door Door does not open when the button is pressed Door currently needs to be opened manually Possible fault with the motor, sensor, control button, or electrical components Scope of work: Inspect and diagnose the issue Repair or replace faulty components as required Ensure the automatic function is working smoothly after repair Requirements: Experience with automatic or motorised sliding doors preferred Please bring your own tools and equipment Timing: Flexible, but we would like the issue resolved as soon as possible

I would like assistance to remove the cabinet draw beneath the washing machine. Will require assistance to lift the washing machine out, unscrew the cabinet draw and remove the kick board + base and slide the washing machine back into the slot. Essentially we want the front loader on the ground. Hope that makes sense.

Our oven has stopped working. It worked last week and now it will not switch on. It has a safety switch which won’t turn off. We have checked and tested the power switch board

The engine won’t turn over. Not electrical issue (battery and spark plug replaced) Most probably adjusting valves which I tried doing but probably not doing it properly. Need diagnostic and fixing, was working fine before so can’t be a major issue as it was serviced etc few months back.

Need an old 60cm under bench electric oven with its own power switch to be disconnected. New oven of same size to be installed in same place. Old oven to be taken away and disposed of. Would like this to be done in next 2 weeks (date to be finalised).

Fit a new washing machine seal to front loader hiscense machine (i already have the nee seal)

Move washer and dryer down under house to laundry. Minimal steps.

Install new oven and cooktop, disconnect and remove old appliances from premise.

Remove bracket between dryer and washing machine and remove dryer and dispose of it and install new dryer

I have a sungrow SG8 inverter. It has a control panel flashing red light. It has error code 010. Restarting has no impacts.isolatong/desolating has no impacts. Smart meter has flashing red light (status =ok) and flashing comes light (status =ok). Solar inverter is measuring smart meter voltage and panels voltages (2 arrays). In MSB look like a large fuse has blown (discoloured blackened). Need electrician whom has worked on solar systems to investigate and repair. Quite flexible on time. Available 6am to 2:30pm daily. Sooner the better, obviously. We have two switchboards, a MSB and a DSB.