Book a trusted oven repair and installation expert in Sydney Eastern Suburbs

Hi, I need a qualified, licensed electrician to run a dedicated circuit to connect a new kitchen oven. Scope of Work: * Run a new dedicated circuit from the main switchboard to the oven cavity (less than 10 metres). * Install 1x RCD-protected circuit breaker (RCBO). * Install 1x circuit breaker enclosure * Supply standard thermal cable (4mm²). * Hardwire and test the oven. * Replace the existing connection of the oven to the new circuit. * Issue a CCEW (Certificate of Compliance for Electrical Work) upon completion. Site & Access Details: * Access Type: Easy roof cavity access. * Switchboard: Circuit breaker enclosure is to be installed near and separate to the switchboard. * Appliance Specs: Mistral 3.25kW builtin oven. * Must hold a valid NSW Electrical Licence (please state licence number in your offer). * Must provide all materials (cable, enclosure, RCBO) and tools. * Must issue a CCEW certificate.

I am looking for a qualified and experienced oven technician to inspect, diagnose and repair an oven light that has stopped working after a recent cleaning service. The oven itself is functioning perfectly. It turns on normally, heats up correctly, and all cooking functions appear to be working without any issues. However, after the oven was cleaned, the internal light stopped turning on. Before the cleaning service, the oven light was working normally. The issue was only noticed after the cleaning was completed. There is no indication of any other mechanical or electrical problems with the oven. I would like a technician to investigate the cause of the lighting issue and determine whether it is related to the light bulb, bulb socket, electrical connection, light switch, or another component that may have been affected during cleaning. The main priority is to restore the oven’s internal light without affecting its existing functionality. I am not looking to replace the oven, as it is otherwise in excellent working condition. The technician should have experience repairing domestic ovens and be able to safely inspect the relevant components, identify the fault, and carry out the necessary repair. Please bring appropriate tools and testing equipment. If a replacement bulb or another small component is required, please advise me of the additional cost before proceeding. I would appreciate someone who can complete the inspection and repair in one visit if possible. Please provide an estimated call-out fee, labour cost, and availability. I would also appreciate confirmation of whether you have experience dealing with oven lights that stop working after cleaning. The oven is otherwise operating normally, and the repair is specifically for the internal light. Thank you

I am looking for a bricklayer to cut and lay bricks for our pizza oven base based on the attached setout. We are looking to paint the bricks after laying so we would want the mortar to be tooled on visible areas. We also require storage / access beneath bench / oven base so we would also use a lintel. All bricks and sand / cement / lintels will be provided (if you could advise quantities for sand / cement). Access to the the back of the house is through a small passage down the side approx. 600mm wide. I am happy to assist in carrying materials / tools to work area. All the bricks have been neatly stacked 1.5m from work area. Recycled common bricks to be used. Please let me know if you require any additional information. Note works does not include closing of the top with white insulated bricks in example photo bottom left. We will complete a slab and sit these in.

Bricklayer needed – pizza oven base in Maroubra Looking for an experienced bricklayer to build a sturdy brick base for a pizza oven in my backyard in Maroubra. The job is for the oven base only. I can provide photos, measurements and oven details to help with quoting. Access to the backyard is through a narrow side passage, approximately 63 cm wide. Please let me know your availability, estimated cost, and whether your quote includes materials. Photos of similar work would be appreciated. Thanks, Robbie

AEG oven not working. Display shows that it needs PYR clean however, I could not get this process to start despite following instructions in manual.

I need the burner changed inside the oven, easy job. Please see the photos for example

My Westinghouse house oven, stovetop gas ignitor will not stop clicking. I believe one of the four ignitors (far back on the left) needs to be replaced. But it may potentially be worth replacing all four just to be safe. I've tried cleaning the surrounding area and re-positioning the gas stove tops on each one, which has fixed it for a short period. But it occasionally gets set off when the stove top gets hot or I rest something heavy on the gas top. This would would require a licensed electrician to complete. Although I know this is probably a five minute job to fix (assuming you have the spare parts as I do not). Ideally please come to the job with the required spare parts to complete it. Have provided oven details in the images in case this is helpful. Not bothered about when this is done -ideally in the next 2 weeks on a Mon, Wed or Fri would be great.

Remove old oven, cut and smooth out caesarstone, install freestanding 60cm oven with gas top.

I have a built-in Westinghouse oven under a gas cooktop, and there are visible gaps around it that need to be tidied up. Photos are attached. What needs doing: • Close the gap along the bottom of the oven where the chipboard is exposed (a kickboard or plinth strip, or a cut-to-size board painted or finished to match the cabinets) • Tidy the gap above the oven with a suitable trim or filler panel

A - Quote to check my Oven and Cooktop connection to see if its ok for a new Oven and Induction Cooktop. B - Replacing an existing ceiling fan with a new one

Westinghouse gas oven isn’t working

New oven - need it installed and old oven removed

Oven not lighting, only works occasionally

Smeg oven SFRA9300TVX light bulb to be replaced

Installation of new 60cm freestanding electric oven.

The inner glass panel of the oven door has come loose from its metal frame.

Looking for a licensed electrician to help install 2x new 60cm Fisher & Paykel built-in electric ovens (one microwave combi oven, and a normal oven). Would be great if you can take the old ones away to dispose of also.

We need a gas oven connected - see images. And a dishwasher hose with Aquastop valve fitted to a De Llonghi dishwasher. Must be qualified gas fitter and able to do both jobs. Easy parking, ground floor house in Bondi.

Looking for an electrician to install a new oven, really straightforward job, just needs wiring (see photos)