Hire a trusted gas stove repair and installation service in East Melbourne

Disconnect gas cooktop, last gas item in my place. Should be straightforward. No need to reconnect.

Suspecting age cook top to be faulty since the electricity dripping.

To check the gas cook check if it’s faulty as power dripped.

Replace old 60cm gas cooktop with new gas 60cm cooktop. Kitchen benchtop is laminate.

Two out of four gas cooktop is not igniting. Have clicking sound when turning the knob. No gas smell. Hot water in the apartment is working fine. Brand: Blanco Must be a licensed gasfitter.

Just need to get a certified person to install a new gas stove to replace the old one, simple job,

Need a new gas stove installed and connected by a licensed gas fitter/plumber

Hi there need to install new cooktop Already bought need to install Thanks

Cooktop did not arrive until Feb 25 and my brother has done carpentry so now ready to install! Sorry for delay in accepting but did not know delivery date of Chef 60cm cooktop - have just found out it is not until 5th February so installation would be on or after that date... Prior to commencing works carry out gas fitting line pressure test to ensure sound -Isolate gas to property, remove existing cooktop, and fit new gas isolation valve under bench in approved location to meet current regulations -Fit new customer supplied gas cooktop, including regulator, and connect to fitting line (Chef CHG644SC) -Carry out secondary gas fitting line pressure test -Commission appliance as per manufacturers instructions -Clean area and remove all rubbish including original cooktop from site for disposal -Supply relevant certificates of compliance

Hey looking for my Bosch gas stove top replacement with a exact same one but a bit newer and I also require a gas certification with that.

Thorn brand commercial gas stove. 3-4 Pilot light is not staying. And make wok fire more strong please

Replace existing old gas cooktop, the original one is narrow in size, so probably need some small cut job on the benchtop.

There are two pipes running in parallel from the meter to the house, see the attached photos 1. cooktop and heater 2. hot water unit. What needs to be done: 1. Cap off a pipe At the copper T junction at the gas meter, cap off the one to the cooktop and heater. (1'' copper tube) 2. Reconnect cooktop and heater to another pipe At the hot water unit(3/4'' copper), add a T junction, and connect cooktop and heater(1/2'') to it. current joints are under the house, need about 2.5m and 5m 1/2'' pipe to connect them.

Gas stove need reiar 1 of the burner does not ignite tried to ignite it manually , however unsuccessful it will shut off immediately. location is in Doncaster East, Need to arrange time with Tenant

Installation of a new gas cooktop required and removal of the existing. Current bench cutout is 870mm x 390mm. Cutout for the new cooktop needs to be 885mm x 405mm as per the manufacturers specs. The kitchen benchtop and cabinet sides underneath will therefore need to be cut slightly (it's laminated board - refer to pictures). Additional information: Current cooktop size is 975mm x 455mm. New cooktop is 930mm x 450mm. Overall benchtop depth is 595mm.

Need a certified gas fitter to switch over a gas cooktop. Must have the necessary licenses to do it. Ideally, it needs to be done before Thursday, 19th. Switching from an old gas cooktop to Fisher and Paykel cooktop. Regulator and isolation valve easily accessible in cupboard next to.

I need a new rangehood installed and a new gas stove installed. I will supply both. Please quote for; -Removal and disposal of old stove and range hood -Installation of stove and rangehood -Running rangehood exhaust outside (through a brick wall) -Works must be compliant with rental standards

I need a stone mason or benchtop specialist to adjust my granite benchtop cut-out so my new gas cooktop can be installed. The gas fitter advised that the current cut-out needs to be widened before installation. Current cut-out: 470 mm x 840 mm New required cut-out: 490 mm x 850 mm (Only small trimming needed – approx. 20 mm depth and 10 mm width) Job details: • Granite benchtop • Straightforward trimming of the existing opening • Must have correct stone-cutting tools (diamond blade, water/dust control) • Hoping to get this done ASAP so the gas fitter can return Located in Surrey Hills. Please let me know your availability and your price.

Replace existing old gas cooktop, the original one is narrow in size, so probably need some small cut job on the benchtop.

gas glove repair. Fire always disappears after couple minutes.