Find an experienced gas fitter in ACT

The temperature is currently -7C instead of -22C. We suspected it ran out of gas. Need someone to refill it

Need a licensed heating tech to diagnose and repair a Brivis Buffalo 120EM (natural gas ducted heater, 1994) in Gordon Canberra. Pilot light stays on and fan runs, but main burners do not ignite. New thermocouple installed. Suspected gas valve, controller, or safety switch fault. Require full diagnostic and repair advice. Parts replacement may be needed. Easy access, flexible timing (weekends OK).

Replace old 60cm gas cooktop with a new Bosch cooktop. Remove and dispose of the old cooktop and packaging.

1. Modify and replace a stove thermocouple for a 1990 Gas Chef 600 oven. Part no longer available. Stove oven lights but gas will not stay on. 2. Service Stove.

Have no hot water coming out,17 years old unit, need repairs or replacement please

Fix gas ignition on stove

I removed my equipment months back for the floor renovation and now need to put it them back

Service must be done At home

My gas stove is not working properly. When I turn it on, the gas flows. However, the igniter does not spark for any of the five burners

I’m looking for a licensed and insured gas fitter to help with a job at a home being lived in by the owners. The Ortal 110 TS gas fireplace is already installed and framed, and the gas line is in place (compliant and covered under the existing Certificate of Occupancy). I just need you to: Connect the gas line to the fireplace Install the supplied flue and tophat vertically through a Colorbond roof (this is supplied by owner) Seal the flue penetration at the roof (materials to be supplied if needed) Commission the appliance and Provide a Gas Compliance Certificate

Cooking gas chimney air flow need to check.

Disconnect 80's Vulcan gas heater, cap off gas connection, and remove heater, either out the front door to my trailer or you take it with you

Old freestanding oven with two broken legs. Needs to be safely disconnected and removed.

Hi, I’m looking for a plumber to help install my BBQ Island in my alfresco area. It’s getting delivered week of 17th March, so I’d like to get it installed any day after that. What’s involved: ✅ Water connection – The sink needs to be connected to an existing water tap. I’ll provide a 2-way connector (or happy to go with a better option if you suggest one). ✅ Drainage – There’s a drainage gutter for rainwater just behind the alfresco wall but unsure where we can put the drainage, so need suggestions. ✅ Gas connection – The BBQ needs two natural gas connections (one for the burner modules, one for the BBQ). I’ve found a 2-way gas conversion kit at Bunnings, but open to recommendations. ✅ Location: Alfresco area with existing water and gas points. The BBQ will delivered in the alfresco, so no help needed with move etc. BBQ Link: https://www.barbequesgalore.com.au/p/nexgrill-cucina-bbq-island-inc-6-burner-bbq-sink-and-range/CCN6ISLQ.html?srsltid=AfmBOooc5_pvn-Ic9CW4SGKADqRn8Nqyq2U0Lshn6VWydXTI0YYgYcUr I’m flexible on time – happy to do regular hours or even after hours if that works better. Let me know your availability and price. Cheers!

Need to test all commercial gas equipment to make sure no leaking

I am looking gas filter for inadpection and provide me certificate job already completer only for inspection

Gas stove needs servicing, having issues with flame. Knobs also might need replacement/fix

Need a licensed gas fitter to help disconnect and disposed a old gas heater. Accept quote for only disconnect and I can arrange disposal separately.

One burner of my Bosch gas cooktop stops immediately after ignition.