Find a reliable cooktop installation and repair service in Melbourne Western Suburbs

I am looking for a gas plumber to install a gas stove

Supply and Install Gas Cooktop - Chef 60cm Natural Gas Stainless Steel Cooktop (or equivalent) -Conduct gas pressure test to ensure suitable fitting line for installation. -Disconnect and remove existing cooktop. -Install new cooktop in same location. -Provide new connections-Check gas pressures. -Test and commission completed work.

Take out existing and install new gas cooktop. To be siliconed also.

Hello need an existing over removed that is hard wired and new fitted with a 10am plug The oven is brand new and has a 10am plug Will need to have certificate of compliance warranty and insurance purposes Must be certified Straight forward job

change over a gas cooktoop (take out old/install new) in West Foorscray? Laminate benchtop although I think new unit cutout is the same as old (pics attached).

60cm gas cooktop to be installed Stone already cut to.size and old.one removed Need.certifcate

Install Sink TAP, sink and cooktop. Supply pipeline/connector for cooktop to the outlet in the wall. I will supply the water TAP and sink. Connect cooktop to electricity

I need someone to look at my faulty gas/electric range/cooktop. It has been disconnected from the main electrical line temporarily as the igniter keeps activating without pushing any knobs. But doing so stops me from using the oven as it runs on electricity and not gas. Refer to video below.

Measurements 59cm depth 100cm length Width 60cm I need this replaced a a rough quote to send to landlord. Located in yarraville

I’m looking for someone qualified to come and swap over my omega 90cm oven/stove top for a new 90cm upright cooker. It is electric and Gas. Need someone who can do both gas and electrical parts Ideally need it swapped over by friday 9th/10/2026 Looking to pay around 400-550 cash - i am negotiable

Need to install Oven and Pendant light.

Need licensed trades to swap a 90cm gas cooktop for a 900mm Bosch induction cooktop (⁠PIV931HC1E⁠). Scope: 1. Gas: Cap off existing gas line & issue Gas Compliance Certificate. 2. Stone (If Required): Measure existing Caesarstone cutout. If currently 860mm W, trim 10mm off each side to widen to 880mm W x 490mm D. 3. Electrical: Run new 40A dedicated circuit (11.1 kW load), install RCD breaker & isolation switch, hardwire induction cooktop. About 15m between kitchen and switchboard. Single-storey home, tiled roof.

Need someone to check and fix the * Gas Cooktop: Not all burner are working. 900mm unit. * Electric Oven: Door seal is broken and door doesn't close properly. 900mm omega unit. * Dishwasher: Fisher & Paykal drawer unit, not all fucntion work.

Gas burners are not giving enough flame. Need cleaning and servicing. This is a Technika 5 burner gas cooktop.

Licensed gas fitter needed to inspect/fix a 4-burner gas cooktop in Yarraville. One burner won’t stay lit and the other burners have inconsistent flame strength, particularly when several are used at once. Looking for diagnosis and repair.

I’m looking for a licensed electrician who can disconnect hardwired appliances and replace ceiling fans / lights ahead of stripout and painting. I am renovating my kitchen/house and need the following work completed: 1. Safely disconnect and isolate the power to an existing built-in electric oven/cooktop so it can be removed. The appliance is hardwired (not plugged into a power point). 2. Replace 4 × ceiling fans and 5 x ceiling lights with temporary fixtures (all will be replaced later with new lights/fans, current ones need to removed for painting). This is the first stage of the renovation. After the kitchen and laundry strip out is complete, I will also need a licensed electrician to return to connect the new oven and other electrical work, so there will be additional work available. Happy to talk through this additional scope while onsite for the above works. Requirements * Must be a licensed electrician * Please bring all necessary tools and suitable temporary light fixtures * works must occur on 15 September to allow stripout to occur later in the week

Like-for-Like Electric Oven Replacement & Disconnection Task Description: I need a licensed electrician to disconnect my old wall oven and install a new replacement oven (like-for-like swap). The Job: Disconnect and remove the existing built-in wall oven (Chef Classic model pictured). Install and hardwire the new replacement oven into the existing cavity. Details: The replacement oven is already on-site and ready to go. It appears to be hardwired (there is a dedicated switchboard switch for it).

Replace gas cooktop. Remove the old one and install the new one.

Renovation. Install new oven, secure existing power to wall. Add another PowerPoint for gas cooktop. Rangehood is connected.

Hi, I’m looking for a licensed gas fitter to inspect an already installed gas cooktop. Just need a quick check of gas connections, leaks, and overall safety/compliance, and a compliance sign-off if all is okay. If required, a gas isolation valve may need to be added underneath the cooktop. A cement sheet has been installed behind the tiled wall for heat protection due to slightly reduced clearance (around 125mm). Original installer is unavailable, so just after a routine safety check for peace of mind. Location: Melton west, 3337