Find a reliable cooktop installation and repair service in Tarneit

Need to wire up the standalone cooker oven 900mm

One of Gas Cooktop controller not working and its not supplying the gas. But it works as long as it's kept holding.

My gas cooktop burner is not holding the flame. It ignites normally when I turn the knob, but as soon as I release the knob, the flame goes out. It seems like the gas is not staying on after ignition. The cooktop is installed and accessible. See attached photo for reference. What I need: - Diagnose the issue - Repair or replace faulty part - Ensure burner stays lit and works safely Other burners are working fine. Only this burner has the issue.

I have an Omega Hybrid Cooktop (1 gas burner + 4 induction zones). The induction cooktop has already been installed and is fully operational. The gas supply is there.. just need the pipe installed to the cooktop. I have the Omega gas regulator supplied with the cooktop. I need a licensed gas plumber to: • Connect the cooktop gas inlet to the existing gas supply. • Install the supplied regulator if required. • Pressure/leak test the connection. • Commission and test the gas burner. • Ensure everything complies with Australian standards. No electrical work is required. Photos are attached showing: • Cooktop • Supplied regulator • Cabinet setup

Need to replace the gas cook Top (60 cm) I'll supply the new one. Please refer to pictures.

Need someone to remove the existing 50 cm cooktop and install a different one

Cooktop switch no holding gas

Need someone to replace 60 cm kitchen cooktop and Rangehood Canopy , location Tarneit

My gas cooktop flame is low

My gas cooktop does not work properly flame are low

We have a similar problem with 2 gas cooktops in two houses in creekstone estate tarneit. Main gas burner is turning on intially and then turn off.

I need someone to remove a 60 cm oven and a cooktop from property in Parkville and reinstall in a property in Tarneit

My gas cooktop ignition on one of the burners is firing when turned on continuously

Hi mate, I have new cooktop 60 cm which i needed installed in alfresco area. Just needed to glue down and connect to gas supply. What would be the charges?

Need to fit new 90 Cm gas cooktop in place of my existing one but the cut out width is different so need to cut the stone or the wood under . The images from the bottom are attached here with . The existing is 733mm and the new width is 860

I have replaced benchtop and needs installation of new cooktop, old one was already removed

Kitchen gas cooktop burner ignition not working, and top iron stand sealing is loose.

Middle burner is not working in technica 90cm freestanding cooktop and oven. Sparker is not working and light up using lighter then it will run until nob is pressed but if nob is released then it will stop.

* Install plumbing for sink and dishwasher * Install gas cooktop * Pool plumbing: Re-plumb the existing solar heating line to run off the main filtered return line, bypass the solar pump, install a diverter and check valves, connect the return back to the pool.

Got new cooktop, looking for installation support. and install the new ceiling fan in another room.