Find a reliable appliance technician in Bexley

Need refrigerator ice maker repaired and dishwasher cycle repaired

Remootio 3 wifi garage opener device needs connecting to my B&D garage roller door

Looking for someone to give us a hand with solar battery job tomorrow , more works coming next week also

home gym setup machine with pulleys and weights

Hi, I'm looking for someone that can help fit the gas to the bbq and connect the water pipes to a sink on the balcony.

Trim was built around much larger microwave. Needs to be adjusted or rebuilt to suit smaller microwave

Garage door works automatically but not with remote. Something need to be done. Could be a very easy fix.

install this bbq https://www.appliancesonline.com.au/product/napoleon-lex-605-black-built-in-natural-gas-bbq-bilex605rbink-au/

home gym setup machine with pulleys and weights

** MUST BE DONE TODAY AS WE HAVE AN OPEN HOUSE INSPECTION AND THIS NEEDS TO BE INSTALLED ** Old clothes line broke. Existing bracket is still mounted to the fence so you may be able to reuse it otherwise you can use the new bracket that came with the new fence mounted clothes line. It’s the exact same brand and should be the same model too. Need someone to attach it. Please also check the integrity of if the existing bracket because if it is damaged then it will need to be changed too. Pictures attached of mount location, existing bracket, and the clothes line.

We need someone to help install our washer! We needed a longer hose for the set up so the movers weren’t able to.

“Stirling dryer already opened, we just need help repositioning the door sensor that came loose. Everything else is working fine.”

I need a licensed gas plumber to inspect and repair a suspected gas leak coming from the control knobs on my SMEG gas stovetop. Smell is faint but consistently noticeable only around the knobs, potentially also under or behind the stove. Need someone to: Test for gas leaks (using proper gas detection equipment) Identify the cause (likely valve or seal issue) Repair or replace any faulty parts if needed (e.g. valve seals, O-rings, knobs) Ensure everything is properly sealed and safe to use Stovetop model: SMEG (can provide full model on request) Must be a licensed gas fitter, able to provide compliance certification if required. Would prefer someone available in the next few days. Please bring necessary tools and parts or let me know if something needs to be pre-ordered. Located in Bexley

Hi there, I’ve purchased a new Electrolux EVEP614DSE oven, but it doesn’t quite fit into the existing built-in cabinet space. I’m looking for a skilled cabinetmaker or handyman to adjust or trim the cabinet slightly so the oven can be installed properly. Details: Location: Bexley 2207 Job: Modify/trim existing kitchen cabinet (possibly width or height adjustment) Oven dimensions: 596mm (W) x 597mm (H) x 572mm (D) Cabinet Cut-out: 780mm** (W) x 590mm** (H) x 581mm (D) Must bring own tools Flexible with time, ideally within the next few days Can provide photos and exact cabinet measurements upon request Tasks: Increase the cabinet height to fit the oven height Add a cover board on the right hand side to fit the over width

Remove a small washing machine

Converting kitchen cavin for new dishwasher. Setup water supply and drainage.

Removal and dispose of original dryer and install another in its place on wall. New dryer is a fisher and Paykel aerosense 5kg

The pilot light of a gas hot water heater didn't ignite after the gas supply has been recovered. Need someone to reignite the pilot light

Light stuck in on position. Need help

5 year old dishwasher suddenly not operating. No power when turned on. Model in image below