Hire a trusted appliance repair service in WA

Hot plates are working but not oven.

Washing machine stopped working the msg that comes up is it’s the fault is - drum drive issue

Electric Recliner Repair Needed Hi, I’m looking for someone who can repair the electrical mechanism of this recliner sofa. The power is working, and one side of the sofa opens and closes normally, but the right-hand seat is not working. It seems to be an electrical/mechanical problem with that side only. If you have experience repairing electric recliner sofas, please contact me with your availability and price. Thank you! 😊

Error E3100 on dishwasher - I’ve turned it off at the power switch

Fisher and Paykel fridge freezer has stopped cooling, lights working inside though

I have Indian clay oven ( tandoor ) on the top part on it ring is rustic , it”s new oven bought from overseas . Sharing picture

My Fisher & Paykel rangehood control panel/buttons have stopped working properly after the rangehood was cleaned with steam. I suspect moisture may have affected the control panel, switch board or PCB. The rangehood itself is still installed and I’m looking for an experienced appliance repair technician to inspect, diagnose and repair it if possible. Please let me know if you have experience repairing Fisher & Paykel rangehoods and whether replacement parts can be supplied if required.

The spring that holds the door of the under bench oven is broken and need to repair it

Washing machine screw at cover is broken. Maybe it needs to be glued back. Cover does close.

Repair fridge sound and check leaking water from fridge

I need someone to fit new washing machine seal as old one has been damaged i will have the part by next Wednesday so labour only washing machine 2 month old haier its already had old seal removed and front is off just needs fitting and putting back together

Freezer isn't working, the temp is only at 26 degrees and won't go down to minus. Might need re-gas. Located in Coventry Village, Morley.

Looking for an experienced handyman to complete a few jobs at my apartment in South Perth: Scope of Work: - Remove existing fixed rangehood and install the new replacement rangehood (same size) - Drill/cut a new opening through the kitchen cupboard to allow the new rangehood power cable to pass through - If feasible, neatly cover or patch the old cable hole that will no longer be used - Install one wall hook/fixing point inside the apartment for hanging purposes (concrete) - Install one wall hook/fixing point on the balcony wall for hanging purposes (brick) Additional Information: - Previous experience installing rangehoods is preferred - Must be able to drill and cut neatly without damaging surrounding surfaces (see attached photo of the cupboard) - Particular care is required especially for the internal apartment wall to avoid cracking, chipping, or paint damage - Please provide your fixed-price quote for the complete job and earliest availability. Thank you.

I have a Bosch Series 8 (Model WAW28420AU) washing machine that’s getting stuck partway through the wash cycle. It keeps washing continuously but won’t drain or spin. I was wondering if resetting or reprogramming the machine might fix the issue, but I’m not sure.

Electrolux washing machine front loader, error 10 kept stopping multiples time. Still spin, still drain but not sure why.

Dryer stopped working. It turns on and runs, but doesn't heat up. Simpson brand. Has been taken off the wall mount.

Our oven stove top needs repairing or replacing of its gas pilot lighters that don’t work anymore and we have to use a lighter

Bosch series 8 machine the door rubber cap has a cut that is leaking water. Also the back pipe is leaking water, the pipe is fine,its the white cap that seems to be leaking.

I have a Baumatic GEH6018 slideout rangehood. The white front fascia panel drops down and won’t stay up. Both mounting points look corroded and damaged. One side appears to be missing parts entirely – possibly a plastic cap, grommet or screw. I’ve taken plenty of photos and can share them. I just need someone who knows what they’re looking at to identify exactly what’s missing, source the part if needed, and fix it. Property is selling 9 June so needs to be done before then. Located in Innaloo.

Washing machine has been installed to new home, purchased an extended wastage pipe and installed from machine to under sink. Washing machine is now leaking underneath. Cold water hose also needs tightening/tape as there is a slow drip