Hire a trusted appliance repair service in South Brisbane

Stop a Thompson bandsaw from screeching when blade stops

From my analysis of the noise, it seems that the air damper assembly on my LG GB‑455PL refrigerator needs to be replaced. I understand this is a DIY job with no need to access electrical components. I understand it’s quite a quick task to replace with a new one (less than an hour)

Ryoby 36V battery mower wont start. Battery is known good and charged. Suspect a switch is faulty

The kitchen range hood is installed, but the duct only connects to the wall and does not vent through the ceiling. Smoke and cooking fumes are recirculating back into the house. Looking for someone to: • Cut through the ceiling and install flexible ducting from the range hood to the roof. • Install a roof vent cap (rotating whirlybird or fixed) to properly exhaust smoke outside. Materials: I do not have materials ready. Please advise what is needed, and I will purchase them. Requirements: • Experienced in kitchen range hood ducting and roof access. • Must ensure smoke is effectively vented outside.

I have an ikea dishwasher Model- torbsboda - bought 2025 Stop working6 months in seems to be door over extension I have it in a shed so I will need to drop off to you and I can pick up when done $100 diagnoses and let me know how much to fix. Need it done some time before end of march. Thanks

The left-hand side of the toaster operates correctly, with the lever staying down to toast the bread. The right-hand side has recently stopped working, and the lever no longer stays down.

Washing machine leaks , need to be serviced . Haier washer/dryer combo

Water keeps running and won’t stop in the dishwasher.

We have a 2.5 seater electric reclining couch. One of the seat recliner has stopped working we suspect it’s a cabling issue.

Need to fix Dishwasher, problem is water intake or out Bosch series 4

Dishlex DSF6216X dishwasher has stopped working. Attempting to run any cycle results in a “.CO” error and DIY attempts to identify and fix this issue have been unsuccessful. Need repaired.

Nutribullet blender not working. Have tried turning it on with different blades and containers to no effect. No fall/splill/damaging incident.

I have 3x Telstra 4GX Wi-Fi Plus 2 that work then break seemingly without any reason. I can't get any clue what is going on. Perhaps someone with more technical know-how can help fix it.

Mechanism on recliner keeps jamming. Motor is working fine. Suspect mechanism has been bent or out of alignment after a very heavy person has "dropped" themselves into chair recliner was fully out.

Outside bottom panel of dishwasher is not aligned with the body of the dishwasher. It needs to be realigned aligned and screwed back together.

Looking for an experienced technician to inspect and repair an automatic external sliding door at a residential property. Issue details: Automatic sliding external door Door does not open when the button is pressed Door currently needs to be opened manually Possible fault with the motor, sensor, control button, or electrical components Scope of work: Inspect and diagnose the issue Repair or replace faulty components as required Ensure the automatic function is working smoothly after repair Requirements: Experience with automatic or motorised sliding doors preferred Please bring your own tools and equipment Timing: Flexible, but we would like the issue resolved as soon as possible

The engine won’t turn over. Not electrical issue (battery and spark plug replaced) Most probably adjusting valves which I tried doing but probably not doing it properly. Need diagnostic and fixing, was working fine before so can’t be a major issue as it was serviced etc few months back.

We have previously had issues with our ducted aircon causing leaks from the ceiling and it appears to be happening again. Last time there was a blockage in a drainage pipe which led to a build up of condensation that was seeping through the ceiling. Hoping someone can come this afternoon because it’s in our daughter’s room.

My AEG dryer machine is currently not drying… I have a feeling there is lint stuck at the back of the machine. It turns on and the agitator turns as well, but after the cycle has finished the clothes are still damp… I need someone to come take a look and to fix it please

A suitably qualified tradesperson/s to fix a battery powered video doorbell on weatherboard wall. Own supply of video doorbell just needs mounting