Hire trusted appliance installation services in North East Melbourne

Remove a rusted/stripped screw     The screw is located on the front panel, just under/near the detergent drawer. It’s heavily rusted (likely from detergent/moisture exposure) and the head is partially stripped, so it’s not coming out with standard tools. Install a new door seal (gasket)     I already have the replacement seal and parts ready. Once the screw issue is sorted, I need the door seal properly fitted and secured. What I’ve tried so far: Applied WD-40 and let it soak Attempted removal with socket wrench (imperial sizes) The screw is still stuck and difficult to grip What I need: Safe removal of the stuck screw without damaging the panel Installation of the new door seal (correct fit and alignment) Use of appropriate tools (e.g. metric sockets, screw extractors, clamps for seal) Notes: I already have all replacement parts Prefer someone with experience in washing machine or general appliance repair Open to drilling/extraction methods if required, but would prefer minimal damage.

We have a new range hood installed and need to add a flue for it. It's on an outside wall. We want it to vent outside. See photos. We will holes cut and need the ducting as well.

To replace the electric oven and dispose of the old one. The oven will be supplied.

I got a new induction cooktop, I need that cooktop to be installed Anand the wiring is already done. But the safety switch needs to be installed

Install washing machine seal asap. See photos for unit details. Part ordered from LG.

A number of Miele appliances:ovens(2),microwave,dishwasher,warming drawer,refrigerater,rangehood,gas cooktop,washing machine,washing dryer. All appliances 5 years old operating fine and time for maintenance check.

We recently installed a new oven in our investment property and need to have a trim installed around the edge to cover the slight gap. Need someone to source and install a trim edge.

As previously mentioned old rangehood was 73cmx 39cm so cut out is 70cm x 35 cm and some carpentry (or another way) will be needed to fill the gap for new range hood sizes of approx 70cm x 29cm

We need someone to install and service our up right hoist in our new mechanical workshop

Need the broken electric cooktop to be removed and install the new . Attached a picture of the model of cooktop. The old and new are the same brand and model

We need to reinstall our fire heater after flooring installation. It is missing 2 screws, but is all functional, exhaust is in place so no roofing work should be needed.

I need a certified electrician to install an oven. It’s currently a plug base and needs to be switched to a hard wire. We need a certificate and an invoice

Need someone to look at the site to see how to install the rangehood

I need a handyman to install a rangehood in a granny flat. It has a chimney hole currently in the position above the oven in the picture. I can supply the rangehood.

Remove broken door seal and install new one.

Remove existing oven & replace with new built in oven 600mm Bosch series 4.

Have moved into a new house. Require old oven to be disconnected, removed and disposed. New oven to be installed and connected.

Hi I need someone to install 60cm Recirculating Slide Out Rangehood properly. Old one has been removed.

Supply and install 7 Double GPOs in a Vacant two-storey home - refer to photos, blue tape roughly where we’d like the installation 5 points upstairs (existing PowerPoint exists in each room) 2 points downstairs (below split system AC unit, and in front walk way) Note: I am repainting, so if you need to make small cuts in the plaster to fish cables downstairs, that is fine. I have the 7 Wall Plates (Clipsal Iconic) already. Will need to supply Cabling + Mounting Hardware. Must be a Licensed Electrician (COES required).

Ringdoor Bell camera installation.