Hire trusted appliance installation services in Adelaide

Looking for expert recommendations and installation for a fireplace in our new living area extension.

I want to prepare and install the cctv for the new house . Please send me your offer, cctv model and information for five cameras.

I need a new dishwasher installed existing plumbing.

Install solar/batteries ev chargers, heatpumps

Install an electronic automatic gate opener in Littlehampton SA. Product is Richmond Automatic Gate Opener For Single Swing Gates. Includes 2 x 12V 7Ah Batteries. AC wiring must be installed by a qualified electrician.

Licensed professional to install a Scandia Fraam Sheer Indoor Convection Wood Heater with hearth, flue kit/extension and connect electrical components (no power point immediately adjacent), work must conform with Adelaide Hills Council regulations, Australian/New Zealand standards (AS/NZS 2918:2018) & manufacturers recommendations. Contractor to view and measure location, provide purchase specs (size/number of flue kits), advice and guidance, I can purchase necessary items from Bunnings - heater, hearth, flue, flashing etc), contractor to install everything to specification. Additional Info - Corner installation (see photo) - roof trusses have been designed to accommodate a flue in that corner. Single storey house (3m ceilings + roof cavity, Highland Tray roof cladding).

Looking for a reliable and experienced Tasker to complete the following: • Remove dishwasher from ground-floor kitchen • Remove existing dishwasher from upstairs kitchen • Install ground-floor dishwasher into upstairs kitchen • Move 300L fridge from ground floor to upstairs • Bring same-size fridge and dishwasher from upstairs down to the ground floor Requirements: • Must have appropriate tools for dishwasher disconnection and installation • Sack truck or stair-safe trolley essential for moving fridges • Careful handling through internal stairs required This task should take no more than 30–45 minutes for someone experienced.

Disconnect my oven ready to move to next home

Built in unit. This is a new replacement. Previous one was fully connected.

Pickup for product is Gepps Cross Homemaker Centre today please. 8KG dryer.

We have a small washing machine comes from oversea. Today it accidentally fell off the table and stopped working. It won't turn on even when plugged in. We need to check if it can be repaired as it has only been used for two months, and if it can be repaired we want to fix it.

Install a fire place flue and remove existing flue

I have a small outdoor patio area covered by a pergola with Alsynite roofing. I need an anhaust fan or rangehood installed so when I BBQ or use a smoker the smoke gets taken away. Im not sure what sort of fan would be needed or how it would be installed thats why I am looking for someone qualified and experienced to talk the job over with. Pricing is indicative at this stage. Thanks

To install a Ring battery operated doorbell. Everything is in a box including screws, plugs etc. You will need an electric drill to drill into the brick veneer .

The dryer belt on my Stirling SHPD80W snapped, I’ve ordered a new one and am unable to figure out how to loop it around the drum.

30 gym equipment installations looking for experienced. Some of those not instructions.

I have a new washing machine that needs the bolts removed, noise cancelling pads put on and hoses connected.

Please help install a new washing machine - LG Wash tower (stacked washer/dryer) - 130kg, 600mm (w), 1650mm (h) I bought this new machine from LG official website, however, LG does not offer installation service in Adelaide (annoying). I need someone to help Power/taps available already, so no further power/plumbing works required.

Need a combustion heater Flue kit installed. Needs to go next to where a previous gas heater was based and has access to the ceiling and roof (see images). Have full kit ready to be installed and combustion heater in place. Gap between ceiling and roof line approximately 50cm. Tiled roof but any tile alterations (trimming etc) will be done. All kit ready to go. Just need someone who’s done this before.