Find a professional mobile car dent repair in East London

Motorcycle gears not shifting properly

Rear wheel puncture on budget bike. Very small one left I cannot find. Also seal any others remaining if needed

Hi, I’m looking for someone to carry out labour-only work on my 2016 Peugeot Partner. I’ve already bought all the parts. Work required: Replace front brake discs (rotors) and pads (both sides) Replace both front suspension arms (both sides) Replace leaking thermostat Please quote for labour only. Location: Hainault (IG6). Include estimated time to complete and earliest availability. I’ll award the job to the most competitive, reputable quote.

I’m looking for someone experienced with water tanks/plumbing repairs to fix a water tank installed inside my mobile valeting van. The tank has developed a leak around the lower outlet area, which appears to have been damaged/affected by heat from the generator positioned nearby. There is currently some old sealant around the affected area, but it needs a proper permanent repair. The water outlet/tap/valve is also leaking and needs to be repaired or replaced. I need someone who can: • Inspect the tank and identify exactly where it is leaking. • Properly repair and reseal the damaged tank/outlet area. • Repair or replace the leaking tap/valve and fittings. • Pressure/leak test everything afterwards. • Make sure the repair is strong enough for regular use in a mobile valeting van. I can provide photos of the damage. Please bring the necessary tools and advise if any replacement fittings/parts are required. Location: East London (E14). Ideally looking to get this repaired as soon as possible.

Car roof lining repairing for the inside

I have a 1993 Talbot Express camper with the 2.0L petrol engine and Solex 34 PBISA 16 carburettor, and I'm looking for someone experienced with older carburetted engines to diagnose a running problem and properly set up the carburettor. The van has developed an intermittent cutting-out problem. It can run normally for quite some time, but then begins to hesitate and cut out. Pulling the choke out slightly seems to help, although it doesn't always prevent it from stalling. A garage recently replaced the mechanical fuel pump and cleaned the carburettor, but the cutting out remains. Since their work, there is also a noticeable hesitation/lag when accelerating. I've done some basic investigation. Fuel is reaching the carburettor and the idle cut-off solenoid is operating, but I haven't been able to see any fuel discharge from the accelerator pump when opening the throttle with the engine off, despite testing immediately after the engine has been running. Would you be able to diagnose the cutting-out problem, check/repair and tune the Solex carburettor, and rule out fuel-supply or ignition issues if necessary? I'm based in Bow, East London. The van is a high-top short-wheelbase camper and currently can't drive longer distances.

I have 4 diamond cut alloys that need smart repair, you must be mobile.

We need someone to repair our sagging headliner

My daughter car is fiat 500 toy ride on car , the battery is getting charged and the car is not moving when they press the pedal front rear neutral nothing working

My head lining is little bit broken

The bike is a TREK Powerfly 4 FS - the chain started slipping yesterday on a ride. The bike is 18 months old and completed around 550 miles

Peugeot 2008 damaged door loom wiring needing to be repaired. Common on french cars

AUDI 2002 A4 GREY INTERIOR HEADLINER REPLACEMENT

Deep scratches - see the photo

My throttle for e-bike is not working

Steering wheel leather is ripped and needs restoring. Wheel us brown leather from Lexus LS500 2018.

Mobile car ac repair. I got a leak in my ac system. Honda civic fn2 type r

Bogs down Runs and all just bogs down under revs hyundai petrol strimmer

Motorbike puncture repair

Cycle tyres puncher I need to change tube