Find a local circuit board repairer in West London

I have a decent treadmill which I was given a while ago - it’s the type you get in the gym so good quality but about 15 years old. It has worked fine but I’ve only used it lightly - today it kept tripping the circuit board - it’s on the kitchen ring but in the garage - it powers on but as soon as you select the workout and the motor turns the best it doesn’t work. I’ve opened it up - it does look a bit old inside - but can’t see any loose wires - one thing I saw is a green earth wire loose - I tried to reattach this under the screw it was attached to but it still trips but could be something related to that? There is a black breaker button near the main switch which doesn’t seem to click anymore - plus be that?

Remove x4 relays from circuit board and install / solder x4 relays . It’s for bmw module .

Tripping of electrical circuit

Rewire sensor wire into circuit board of an ic300pro static training bike

When switched on it beeps on and off and doesn’t heat the rails. Found this on line https://universaldiscoverymethodology.com/2024/01/11/repairing-a-lakeland-drysoon-clothes-airer/

I need to repair the FireWire ports on my RME soundcard

The recorder is connected to a hydraulic rail press which measures the strength of a weld before we go into production.Our electrician has tested all connections and working ok so he believes it is a component in circuit board causing issues.

desolder a capacitor from a circuit board and solder it in another circuit board - Due date: Needs to be done on Tuesday, 27 February 2024

Circuit board repair , cleaning product leaked inside - Due date: Flexible

It is a circuit board from a BMW diversity antenna that looks to have suffered from water ingress. - Due date: Flexible

I need to check and fix a small circuit board of my kitchen cooker hood. I have unmounted the board and can bring it where necessary. - Due date: Before Saturday, 28 January 2023

Car remote wo t rekeSe steeri g - Due date: Flexible

Replace old circuit board - Due date: Flexible

I have recently purchased a vending machine the unit powers up fine however in order for the coin mechanism to work it needs to be plugged into a connector on the PCB, however the connector does not appear to be sending any power at the particular connector. I need someone that would be able to diagnose and repair - Due date: Before Tuesday, 27 September 2022

Change a diode on a nero sport treadmill - Due date: Flexible

Replace motor and circuit board. Parts already purchased. - Due date: Flexible

Car telematics pcb needs repair

I have a PCB that controls a commercial roller shutter. The PCB connects to the "up" and "down" contactors which make the shutter move up and down. (Via a chain motor) It also connects to a 3 button switch and and a key switch, which control the motor . The shutter is not going up or down when the push button or key is used. When the contactors are depressed manually, the shutter moves. Power is getting to the motor. this leads me to believe the PCB has failed. Ideally looking for someone to test the PCB and components and repair if possible.