Find a local Tasker to repair your suspension near you

I'm looking for a garage or mobile mechanic to do some work or help me (beginner) on my Triumph GT6, it's in good condition but as with any Car. it has some areas that could be improved. Been trying to get the work done here in Lancaster but a couple of jobs are a bit more than a brake pad swap and no useful replies yet, though early days. No idea re cost, per job would be better It needs: Front shocks/springs (might as well), easy ax whole bonnet tips forwards Rear shocks/springs (definitely needed) still has updated Rotoflex system, would replace Brakes need a bleed, it has front discs, rear is drums, ideally would want rear discs too. It has no mirrors fitted yet, I think it was a very recent rebuild, also came with a nicer steering wheel and an LED light kit. The two larger jobs are: New rear suspension setup to bring it to a mk3 final version without the minimal issues of an early mk3, its a mk2 setup at the moment so not terrible but still Rotoflex. Convert to 14" 5J wire wheels/tyres

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Offside Rear Outer sill on a Honda Jazz 2006

I bought the lowering springs for my car and I need someone to install.

Car Front and rear suspension changed (Coil and Shock). Ford kuga 2014 2,0 Diesel. Can provide the parts to make it cheaper.

I have had trouble removing old rear upper suspension arm - it's disconnected at the hub but cannot release inner bolt. I have new part ready and car is jacked up

2 control arms 2 sway bar link 2 tie rod Parts ready to go just need mobile fitting send me prices

Rear axle beam replacement" o "Rear suspension subframe replacement". I need to know how much it will cost to make this change and install the pieces that go together; I already have the parts.

Suspension mounting components corroded (MOT fail)

Do not drive until repaired (dangerous defects): • Offside Front Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) • Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) Repair immediately (major defects): • Offside Rear Lower Suspension arm pin or bush excessively worn inner rear bush (5.3.4 (a) (i))

Tesla's Model Adaptive Air Suspension is not working well. CREAKING NOISE AND MAKE THE STEERING HEAVY AND DRY.

When not used regularly the car loses air from rear suspension. It re-inflates once the car is in use.

I have the suspension arm just need a mechanic to fit it

Rear air suspension not working the back of my car is sitting very low the front looks ok and feels ok when driving but the rear is jumping all over the place

To replace me front lower suspension arm for my Volkswagen Beetle and i have my own parts

egr valve 2 tyres 2 suspension arms. 1 of the tyres is on the mental under the rubber tyre. The 2 suspension arms are pretty much at the end of there lives. Well I think so. And the engine turns over but won't start.

Sand & paint car control arm holders - will provide paint, sandpaper, brushes

Need both sides of my car front sub frame mounts replaced, im happy to do the work to remove as much as you need for easy access

To fit air suspension to a 2019 ford ranger

2 front tyres Far side suspension rear Honda crv 2008 Part worn is fine

I would like the replacement of the rear coil for Mini Cooper replaced bough new one