Find a professional awning contractor in Outer East Melbourne

I posted this job yesterday but not sure why it’s gone - sorry to those who responded. Need these jobs done Monday morning: 1. Two of my doors that used to work perfectly suddenly acting up, not closing properly. Bedroom doors. X2 doors 2. 7 windows locks to look at, to be replaced or fixed, up to you however u want to do it - at your own cost as long as: I) they can be closed and open again II) no more gaps between the window frame or sorts Iii) some of the windows need to be caulked as cold air is getting in 3. Cut a small board, fix up, to fill up the hole on top of window frame x2 probably 900mm x 5-10cm per gap - no idea why it’s this way when we moved in. Clear that leaves around too. Will release payment only upon completion. One day job ideally.

There is a fixed canopy on top of the balcony that has broken sheet of polycarbonate. I will provide a replacement canopy of same dimensions to replace it with. This task is just for replacement with the new one I provide. The dimensions are 2 canopies of 1200x800x210mm

Need to put a up a Mountain View Plastic awning above a doorway. Approx 4 metres wide. Awning itself is a metre out from wall

I need a business to fit a large motorised retractable awning to my door above the gutter over a patio area.

Hi! I'm looking for a friendly and experienced carpenter or window repair expert to come by and do an initial assessment of some rot damage on an old bay window with awning sashes. There’s a bit of work needed both inside and out, and I need someone who can help figure out the best approach before we lock in the full repair. What I know so far that needs attention: Partial sill replacement (including some internal inlays) Inlay work on both corner coverboards (inside and out) Partial mullion replacement (where the sill meets the transom) Partial transom replacement Repairs to left-hand side sash joints Replacement of the glazing bar on the LHS return panel Replacing damaged or missing trims and glazing beads This job is just for the initial assessment, with further work to be discussed and quoted after. Est. Budget: $2,500 (for full scope of work)

I have an outdoor fold-out arm awning. JOB: - 3 sml splits repaired, ( largest is 100mm long) skin/fabric. - need the spindle that turns to open blind repaired as it has dropped ( it's currently wired up in place so that it turns ok) - Preferably fabric cleaned up. - Awning metal cleaned.

Install fiamma 45S awning onto a 2022 model Jayco Eagle

Install foldable awning on a brick wall, pictures attached. This is just for installation already purchased awning Awning: 4.5Mx2.5M InstaHut Folding Arm

I'm looking for a capable handyman to install a 3m x 2m outdoor awning. This is the awning: https://www.bunnings.com.au/windoware-3-x-2m-charcoal-easy-fit-awning_p1262181 It needs to installed into our brick wall outside in our courtyard. I'm looking for someone with all tools and to assemble the awning also. Installation to take place in Rowville 3178 ideally on Sat 11th Jan, flexible with time. Can be earlier than Sat but not later. Thanks.

The awning is already assembled. The anchors and screws already been drilled and secured using ramset chemical. Problem:- The distance of the screws to each end is off by 2cm. As per the picture these screws needs to be 2cm to the right. The left side is already installed. Job:- 1) Remove the screw protrusion (as per picture). 2) Drill and install 2-screws 2cm to the right of current location. (This is in essence sort of moving the screws 2cm to the right) 3) Install the (Instahut) motorised awning (already assembled). Pictures:- Motorised Awning.png - Motorised Awning to be installed Install Wall.png - Red circle marks the installation location. Problem Wall.jpg - Right side of the wall which needs to be corrected.

I need you to replace 2 or 3 very large fixed guide electric outdoor awning fabrics. Can I get a quote please?

I need help to get a canopy awning installed on the decking external wall that's rendered. Canopy awning is 6m*1m wide. Already purchased it. If possible, will like to get it installed by Christmas.

I’m looking for someone to come and give me a price

One window in a bedroom upstairs is rotten and needs replacing. Seeking someone to replace entire colonial style window. Job includes removal of rotten window and replacement with new window.

front wave edging has come away

Awnings installation , Picture of my house, backyard where I want it installed

I'm looking for a build and fit for an awning window to replace a louvered window in our laundry. I will remove the louvered glass and fill-in the holes in the casing/trim. I have attached measurements. I would like to replace the clear glass with a custom made (I will make) stained glass window

I need someone who can install awning for me in Rowville Photo attached where awning need to be installed. Attached link is for awning where sizes are mentioned. Area is concreted and easy access. 2 labours on site will assist you. https://www.bunnings.com.au/windoware-4-7-x-3m-striped-semi-cassette-outdoor-folding-arm-awning_p0340544

Vinyl supplied All other parts in working order Vinyl only to be replaced It's a tedious job apparently, so I would like someone with experience please.

Ground floor, brick installation. From the website: “Measuring 4m x 3m, our folding arm awning comprises a powder-coated aluminium frame and a high-quality 300gsm polyester fabric shade. Both frame and shade are made UV-resistant and designed to be durable and long-lasting in all kinds of weather conditions (Only for normal weather condition, extreme weather condition is excluded). To open or retract the shade, a hand crank is provided for easy operation. Mounting the frame and shade is also made simple with the included wall brackets.”