Find a professional floor screeder near you

Looking for someone to do bathroom tiling and cement screed (fall) work for a 2.2㎡ bathroom. Wall tiles: 1200 x 600 mm Floor tiles: 330 x 330 mm Tiles are already supplied. You will need to bring your own cement, sand, tile trim/edge finishing materials, and personal tools. As shown in the photos, waterproofing has already been completed. The job requires approximately half a day for the cement screed (fall/gradient) work, followed by one full day for tiling. Grouting and silicone finishing will be done by myself, so only the screed (fall) and tiling work are required. Please contact me if you’re available.

Current floor is 2 different levels. It needs to be levelled and screeded ready for tiles to go down

I need waterproofing and a screed shower done. If you can plaster as well let me know if not I will sort it out. The shower base wasn’t installed to AS and was taken out.

Tiling water proofing screeding

I need to remove the floor tiles and screed in the ensuite bathroom, 2.9m x 1.5m, only the floor tiles are needed to be removed, not the wall tiles. Everything is removed from The bathroom including toilet and shower screen for easy access and straight forward demolishing. I do have a chisel drill if needed

Jackhammer screed back to floor level. Small job..

Cement Screeding/Floating/Finishing/Troweling a 5m x 4.2m slab Suit handyman with experience and straight edge bar, bull float and hand trowel, professional job not required

Do the sand cement screeding in balcony as per Australian standards. Once dried , we do top coat of waterproofing You do the tiling after waterproof is dried . Tiles supplied . Bring - glue, angle , floor waste , sand , cement and tools. Leave site clean after each working day.

Need a experience concreator to level , trowel and screed for a pour

Bathroom Tiling, Screed & Waterproofing House- Ground Floor - Approx 2.2 x 2.8m 1.9m to two sides of the shower. Rest of the bathroom only 1.5m high tiling 1. Surface Preparation & Screeding • Substrate Prep: Clean and prime the concrete slab to ensure maximum adhesion. • Screed Installation: Supply and install a sand and cement screed bed to the entire floor area • Grading/Falls: Screed must be expertly graded to ensure a consistent fall toward the floor waste and shower waste (minimum 1:60 fall in shower and 1:100 in the general floor area). • Curing: Allow sufficient drying time for the screed before the application of waterproofing membranes. 2. Waterproofing (AS 3740) • Supply and install a certified waterproofing system. Waterproofing to be done x2 - UNDER and OVER screed. • Application: Full floor area (over the new screed and into puddle flanges), shower recesses (to 1.8m), and all wall/floor junctions. • Bond Breakers: Install bond breakers/silicone to all internal corners and transitions. • Compliance: Tiler to provide a Waterproofing Certificate / Form 16 upon completion. 3. Tiling Installation • Floor Tiling: Install Owner-Supplied tiles to the floor. • Shower Walls: Install Owner-Supplied tiles to two (2) shower walls to a height of 1.8m. • Main Walls: Install Owner-Supplied tiles to the remaining bathroom perimeter to a height of 1.2m. • Layout: All tiles to be laid with consistent grout lines (size to be confirmed by Owner). 4. Grouting & Finishing • Grout: Apply grout to all joints (color to be confirmed by Owner). • Silicone: Apply high-quality, mold-resistant silicone to all internal corners, junctions, and base of shower. • Trims: Supply and install aluminum or brass edge trims to all exposed tile edges and doorways. 5. Material Responsibilities by Tiler except Tiles

Need experienced tiler/screeder to screed approx 75m² house Floors already prepped Internal screed for tiles I will supply sand and cement Need level finish (laser preferred) Located in Revesby Ready to start ASAP

Chasing a tiler who can supply and install a sand cement screed to seven bathroom areas for falls from 50mm to waste. Total area combine is 46sm2

I am demolishing 9m2 of tiles and I need to reapply screed. I need a floor screed installer to do the works.

New Underfloor heat mat damaged in 5 places. Needs to have joints and repair patches in these areas. Clear floor space to work in, need it sorted before screed.

Screeding of about 25 sqm - kitchen, bathroom and laundry

I'm a home owner and looking for a Concrete Screeder and Finisher (or quote for entire job) for a patio floor around side of house. Job is in Heidelberg and is approx 10m × 2m, 70 to 100mm deep with outside plinth. Site will be clean, formwork and Base are already done. Concrete will be barrowed from front of house to around side. See attached photos.

Screeding and tiling are required. I have a unit on the first floor, with easy access and parking. The existing tiles, shower screen and waterproofing, will be done on the 14th March. The screeding and tiling are required. The tiles are 200 x 200 mm, the shower is only 900 x 900 with 2 rows of tiles on each side being changed. We are after a licensed tradesman with insurance. Please contact for more information if required. Photos are before tiling is removed.

Supply and Installation of Semi-Bonded Screed MAXIMUM 80mm thickness (0-6m2) USED WHEN THICKNESS EXCEEDS 50mm *Supply and install semi-bonded sand and cement screed to build up floor height and achieve correct levels and falls to waste prior to tiling. *The screed is applied over the first layer of waterproofing membrane, forming a semi-bonded system that allows limited movement while maintaining structural stability and drainage accuracy. * Maximum Thickness: 80 mm * Includes light reinforcing mesh to provide shrinkage relief and additional stability.

Photos now added. I need an experienced concreter to level, screed and bull float an internal slab pour. Location: Ferntree Gully VIC (rear rooms of a studio building). Details: • Approx 3.5–4.0 m³ total concrete • Two adjoining rooms at very slightly different levels (approx 100 mm height difference, brick wall between them) • Total area approx 10 m x 3.6 m • Individual spaces are 6.15m x 3.65m and 3.7m x 3.65m • 100 mm slab thickness in each space • Concrete will be wheelbarrowed (EDIT) through the building to the rear rooms by about 4 men Prep is complete: crushed rock, XPS insulation and reinforcement are all installed and ready. I need someone to handle accurate levelling, screeding and bull floating (EDIT) on this exact day - Sat 14th Feb in the morning. We estimate the pour to take about 25-35 minutes. Should only need you for about 3 hours. This needs to be someone experienced at laying and levelling concrete, and has their own tools.

Concreter to screed and expose 29m2 2.8m3 of exposed agg concrete with fall. We will move the concrete just require to screed and expose.