Find a professional hot water system contractor in Gold Coast

Had a new hot water cylinder installed last week, replacing an old one which didn't have the regulator. We have a very old house with very tiny pipes which means absolutely no water pressure for showers and it's a disaster. Need the regulator removed so its just cold water in and hot (75 degrees) water out to the house. Need complete asap.

I need to get a hot water tank moved on this bottom level apartment from inside the bathroom and we need to reposition it on the opposite side of the wall so we can have a full vanity where the hot water tank used to be in this ground level apartment

No hot water since Monday night. Switch in Mains Box on, but has tripped a couple of times. Hot Water System not leaking so a plumber has decided it must be electrical. Faulty heating element?Thermostat? Faulty main box switch? No idea just need a quote to give me a rough idea. Pensioner discount if available please!

We have a Stiebel Eltron Electronic comfort hot water service. It can take up to five minutes to get hot, then if you turn it off, it immediately goes cold again and can take the same amount of time to heat up. Not sure if we need a plumber or an electrician to diagnose and fix the issue.

Looking for a plumber or experienced handyman who can disconnect/remove a hot water system, adjust pipework, and install a bathroom vanity (already purchased). Open to quotes – budget is flexible depending on experience

Looking for supply and install of a hot water system in Tamborine (not Tamborine mountain) Would like the size to be suitable for a family of 6. Single story home Currently using a solar hot water system but have had problems due to its age so looking to revert to an electric hot water system. Prior to the solar hot water being installed, electric hot water used so a concrete pad is available for the new electric hot water system. Some piping from the previous set up can also be seen. Please provide quote and when you are available, would prefer asap but not urgent. Thanks

Free, parts or scrap. Take away.

Hot water system Washing machine fitted Outdoor hot water

I have a 50L hot water system in ground level unit that needs replacing due to leak. Will supply hot water system.

Need to reroute a hot water pipe in garage. Will to add some length in doing so

Water pressure on both my showers are low. Also the hot water change is too extreme, it goes from cold to extremely hot (nothing in between).

remove the old and fit a new hotwater solar / electricity system (plumber to supply the new hotwater system 300 liter + )

The laundry tap setup. The hot water tap (on the right in the photo) is leaking from around the base of its handle/screw cap. Even when turned off tightly, a slow drip of water continues to come out. This suggests the internal washer or valve isn’t sealing completely. Additionally, water is seeping from the screw cap area, indicating that part of the tap assembly may need new sealing or tightening. Hot water tap handle area (needs replacement). The handle of the hot water tap is in poor condition (loose or broken), which is why it needs replacing. A new handle matching standard laundry taps should be supplied and fitted. Replacing the handle will ensure the tap can be turned on/off if needed in the future and will provide a better seal when turned off. A proper handle will also make it easier to operate the tap and ensure a tight shutoff once the internal issue is fixed. Task Requirements • Fix the Leak: Repair the tap assembly so that no water leaks out. This may involve replacing the internal washer/O-ring or fully capping the line to stop water flow. • New Tap Handle: Supply and install a new hot water tap handle (standard size) to replace the old one. The handle should fit the existing tap valve and allow the tap to be turned completely off. Additional Information • Location: Surfers Paradise, QLD. Please only offer if you can travel to this area. • Scheduling: must be done on the afternoon of Sunday 13 April. • Preparation: Please bring any necessary tools and parts (new tap handle, cap/stopper for the hot water line, washers, plumbing tape, etc.) to complete the job. • Experience: This is a straightforward fix for someone with plumbing experience.

Hit water inlet needs to be sealed

Need to replace 80L hot water system. Old system need to be disconnected and new system installed. Looking for Rheem, Dux or Vulcan hot water system. Please see attached photos

Hot water system has stopped heating . Looking for a Plummer with experience on hot water systems to check it out and provide a quote .

Help fix the hot water handle in the shower, it broke off , it just bounced off. So now i cant turn on the hot water in the shower.

I was wondering if anyone would be able to fix something for us. We have a solar hot water, but now the over flow continuously drips. Not excessive but continuous. Thank you. Would offer more but my dad is only on a disability pension. Appreciate for your help

My hot water system is under the house, and I'm moving it a few meters away. Plumbers are booked for 23/01/25, but I need to sort out the connections beforehand to avoid complications that day.

Hot water unit is leaking inside the dripping and tripping the power.