Find professional local plasterers in Inner South West Sydney

I need an unfinished section of a converted garage framed and plastered to match the existing ceiling/walls. The exposed ceiling section is approximately 6m long x 500mm wide and includes exposed timber/steel beams. There is also an exposed steel column that needs to be boxed/framed and plastered. Scope of work: - Frame out the exposed ceiling/bulkhead section - Box and frame around the steel column - Install plasterboard - Set, tape and sand all joints/corners - Finish ready for painting - Neatly integrate with the existing finished ceiling and walls Photos show the current condition. Please include labour and materials in your quote.

Ceiling needs base coat and top Coat slightly uneven . All material provided by me already onsite . Please need a professional with the right equipment such as vacuum sander. Free anytime Fri sat or Sunday .

Square set plaster on ceiling and patching 3 bedroom villa and bathroom gyprock provided

I hace some decorative plaster cornice that is falling in a small bathroom that needs to be re-glued and reconnected. See attached photos.

Ladies bathroom ceiling (water damage) needs to be removed and redone. Complete ceiling

Add missing cornices and oat h small holes in gyprock wall

Fix ceiling gyprock it has fallen i will provide the gyprock

Hi I need to repair a wall that was previously damaged from a water leak This would involve 1. Replace timber studs 2. Install Plasterboard 3. Patch and paint Regards,

Gyprock to see if possible to do

Re sheet the ceiling with gyprock I will provide material

Looking for a Gyprocker to rectify cut out as per picture can be made into door or just sealed and patched and sanded as well pergola ceiling has been patched but needs Sanding ready for painting and any other minor patching on ceiling as per pic

Mount folding table to drywall I need someone to securely attach a folding table/unit to a drywall wall. The table is already assembled and has a base that sits on the floor, so the wall screws will not be carrying the weight of the table. They are mainly there to secure the top of the unit to the wall and prevent it from tipping forward. There are 4 pre-drilled screw holes along the top rear section of the table. The main complication is the skirting board at the bottom of the wall. Because of the skirting, the back of the table cannot sit flush against the drywall. I have therefore bought two boards/spacers the same thickness as the skirting board to sit behind the table and fill the gap. The job would involve: - Positioning the two spacer boards behind the table - Drilling through the existing 4 mounting holes, through the spacer board and into the drywall - Using suitable drywall anchors/fixings to securely hold the unit against the wall - Making sure everything is straight, secure and neatly installed Please see the attached photos, which should make the setup much clearer. Please bring the appropriate screws, drywall anchors/fixings and tools required for the job.

Install 2 x slat wall pieces onto a gyprock wall will need all own tools. Slat walls provided x 2

We had rods hanging up and we have attempted to put putty on it. We want to just make it look better and paint the whole wall so it blends in

I need someone to Fix hole in wall

I need a wall patched up and fixed, I have the spare Gyprock and putty.

Quick job 3 small prints (lightweight) Hang on gyprock wall

A door was opened too quickly and made a hole in the gyprock wall in one of our bedrooms. Seeking someone with experience to repair the wall.

Replace damaged gyprock ceiling panel approx 1700x1000. Remove old section, install new gyprock, set and sand. Paint optional. Please quote including materials.