Find a local excavator service in NSW

I need a small bore under a new driveway There’s some residual water and we plan to install a sump pit (not needed to quote on) but will need this sump pit to drain into a lower drain Ie. We need an approx 4m, 50mm pvc pipe installed under the driveway Please let me know what equipment you plan to use and if you’ve done this before The sump pit that will be installed (not part of this job) will be on the high side, near the Pailing fence in this photo Thanks

Need pistons replaced and cylinders bored to 86.5mm heads already been serviced etc just need to remove block bore it and install new pistons and put back

Bore 2 holes for water drainage to avoid flooding during rain. Plastic pipe to be fitted within the hole. The while should help water flow outside especially during heavy rains.

I need my existing bore tap connected to my existing irrigation system. The bore already has a pump and works, the existing irrigation runs off mains. Ideally I am able to switch from regular water to bore water manually with a valve.

Moved into a house where the bore has been neglected. Need an expert to come round, inspect, and advise on next steps! It is an old bore No idea how much this kind of thing costs so happy to negotiate!

I need two bushes removed that are about 9ft high and have borers. this would be an easy task with a chain saw or sharp saw. I then want them taken to the tip with a small pile of fence timber. I also need timber framing for the platform in front of my garden shed. I will then fill it with crusher dust and pave it. Size approx 2m x 600mm. I'm keen for these jobs to be done as soon as possible. I was imagining it might be about $40hr but am willing to be guided.

Dpf needs to be removed from car, either a hole cut in top and remove internals and then weld the top back on or drill it out from the exit hole.

Installation of water bore

Replace the floor boards that have borer damage

Need a locksmith that can bore a hole and fit a smart deadbolt in my front door. The smart deadbolt has the same dimensions and specifications as a typical standard deadbolt.

I need to engage the centre bore for three rims from 57mm to 65mm to fit my car's hubs

Boring under drive way for pipes connection (for new water meter)4 to 5 metres

Need experienced water bore driller to start work ASAP.

USE A BORER TO DRILL A HOLE APPROX. 4M UNDER CEMENT - Due date: Flexible

To drill across underneath driveway - Due date: Flexible

Borewater pump's light is on but it wont start. - Due date: Flexible

need a basic lever lock and latch bore mounted onto this backyard door so it can close and open freely from the inside and outside. don’t necessarily need it to be able to be locked as I will put a latch on the inside. Want something like this shown in picture. There’s no signs of drills or holes on the side of door so everything needs to be done - Due date: Before Thursday, 14 December 2023

2011 Honda Lead Have an eBay big bore kit to bring it up to 150cc and need it installed Any help would be appreciated - Due date: Flexible

Supply and install submersible water pump with solar power - Due date: Flexible

Bore 3 holes that are 200mm wide with an auger, to a depth of 1.2m deep and lift poles into place Must have excavator and auger - Due date: Flexible