Find reliable local air conditioning installation services in NSW

Air conditioning install. ground floor, back to back wooden house exterior. As easy as they get. I can assist. 2.5kw Panasonic CS/CU-Z25AKR. No electrics required. I have someone doing the electrics once it is fitted,

New AC required to be installed

Needing someone to install a carrier aircon In a room. Wall is brick.

Installation AC in a baby room -Need to get electricity from protected power point outlet for AC and split system as no power outlet in a balcony and where AC will be installed (there is outlet bottom wall) -need to drill concrete wall for air tube -cover needed to cover air pipe(outside) Circled where the outlet located and location AC might mounted Behind the blind is the balcony Tallawong 2762 Offer please

Need split aircon installed in small office.location seven hills

Need a 2kW Daikin interior unit installed and connected to the exterior unit. It’s back to back. The exterior unit also needs to be connected. I will have the exterior unit mounted on a bracket and the isolator will have the feed for unit ready for connection before arrival. You only need to supply materials for head unit to exterior unit. No materials needed to mount exterior unit or load end from isolator.

Install Panasonic C3.5kW Split System or a similar unit. Description: Looking to get a Panasonic C3.5kW (or similar) reverse cycle split system installed before this weekend. Indoor unit location: marked in red rectangles on attached photos. There is a power socket under there behind the table. Outdoor unit: planning for the balcony, separated by one wall from the indoor unit locations. You can see the drainage in the balcony and switchboard in the living room. Need installer to confirm best position, check drainage options, and provide advice before install. I also need a strata approval and for that 1) Drawing/photos showing clearly where the indoor unit will be installed, and where the outdoor unit will be installed 2) Drawing to also show if any holes are required to be drilled for the installation of pipes etc 3) Drawing to show how the unit will be connected for drainage 4) Installers license and insurance documents Photos attached for reference.

I need to Install new Air conditioner(7KV) .back to back

looking for professional installer who can install split 5kw aircon in granny flat

Remove existing air conditioner. Supply and Install a 7.1 KW air conditioner Fujitsu. Dispose of current air conditioner. Must be licensed. Must provide receipt for warranty of air con unit and labour.

Need a quote for the AC unit and installation, potentially some additional electrical work as it's an older house.

Reverse cycle air conditioning installation. Almost back to back, 2 mtr to outside, see photos. Will supply new unit, about 7kW.

I’m purchasing a used split AC system and need someone who can properly install it.

Aircon model - Akai 2.6kW / 4.0kW Reverse Cycle Split System Air Conditioner - 2.6kW Standard Bedroom installation

Instal new 6kw Hisense or similar split system back to back fibro wall with existing box type to be replaced with existing power supply and 3-5m from fuse box. Flexible time when you are in Blacktown. Must be licensed, insured and registered for gov rebate

We need an AC installer apprentice or labourer to give us a hand for couple hours lifting a ducted system in and out of roof

Instal 2 air conditioners

2.7kW Reverse Cycle 687x420x62mm Window Vertical Opening

C2.5kW H3.2kW Reverse cycle split system (Hisense) Back to back brick wall.

Need someone who can help my one of my boys Fitt off a ducted system. Just install grilles and wall controller and pipe up condenser. Everything else is done. Must be available tomorrow