Find a professional gate installation in Mornington Peninsula

I have a 4m x 1.5m slat gate I need installed. I have all hardware on hand, and also have concrete pad installed ready. Need hole dug for guide post (the one item I don’t have)

I have removed the damaged sheet and purchased a new one. It needs to be installed and secured with nails and there was silicon along the edge where it connects to the neighbours side.

Several brush panels require replacement, and the gate needs to be rehung with an extra hinge & readjusted so it is self closing.

I need a sled locking door hinge repaired or replaced. I also need a new one installed on a side gate.

Have already purchased materials. Just a day or 2 labour cost. With gate motor install with intercom and 240volt transformer

Gate was struck by a vehicle and a wheel came off from the bottom of. the gate panel. Someone needs to be able to lift the panels put in the same wheel with better screws or bolts and realign the panels back onto the track. The gate panels are powdercoat aluminium and lightweight.

Align gates so pool gates close to meet standards

Hello we are looking for someone to rebuild our paling fence/ gate closer to the front of the house.

Hinges can't be tightened so gates won't automatically close. I have two pool gates and require four new self-closing hinges fitted prior to pool inspection. Current hinges fitted are TRU CLOSE by D&D Technologies with four screws

I have a remote that just needs to be paired with my my house motor electric gate. I struggle doing it every time even though it’s a couple clicks of a button. Two silver ones are clones once you parent the tan colour one. The current remote I have working is the circular one

Move back a 4 m-wide side house fence with a gate based on two posts (gate hooked to the house). All tools and materials are provided.

I am in need of a welder to weld a gate hinge to the frame

I need a gate rehung . It needs a new post and maybe small amount of fencing . Plus a sticking door needs some timber shaved off .I will pay for materials needed.

Our gates seem to be broken, in need of urgent repair. They do not close with our garage remotes. Our gardener has also clipped a cable today which has cut operation to close the gates via our internal video intercoms.

I’ve got an automated Colorbond sliding gate that needs cutting down 300mm and re-welding. This is a fabrication job, not a handyman job. Only quote if you can weld steel properly and leave it square and true. The gate has to run back on its track and work with the motor once you’re done, so it has to go back together dead straight. What’s involved: Cut the steel frame down 300mm, keeping the cut square across both sides. Cut the Colorbond infill sheet to match. Re-weld the frame rail back on so the gate is the correct height and still square. Grind welds back clean. Prime and touch up all cut and welded edges Re-hang the gate on the track and check it runs true through its full travel. You’ll need your own welder, grinder, and gear. Job is in Frankston. Please tell me in your quote what welding experience you’ve got and whether you’ve worked on automated gates before.

I need fencing and gate quote

The hinges on the front tailgate of my trailer have rusted through and broken off. I need them replaced with the same type and welded onto the trailer.

Metal plate connecting the fence post to the gate has rusted off. All 3 other points are ok - needing a new plate attached from fence post to gate somehow, see photos.

Need help to investigate a toilet - noticed that tiles are breaking up and swelling which could indicate a leak

I need a gate made and installed including lock and mesh screen