Find an experienced gas fitter in QLD

I’m looking for a licensed gas fitter to install a new gas bottle connection at the property. This is a new setup, so the job may include installing the required regulator, piping and connection point, connecting the gas bottle, testing for leaks, and ensuring the installation complies with relevant safety requirements. Please let me know your availability

Inspect gas leak and quote for part replacement

Looking for a licensed gas appliance technician to inspect and repair a gas cooktop. Cooktop: Kleenmaid CH711XFF - At least one burner does not stay lit — it lights while the knob is held down, but the flame goes out once the knob is released. - Another burner continuously clicks/sparks whenever the cooktop power is turned on, even when the knob is not being pressed or turned.

I need to change the gas bottle over but the connection has siezed up

Easy access, open the cover and it’s right there on side of van. I had a gas inspection done and it failed due to hoses needing replaced. Everything else is in good working order. Just need that done so inspector can sign off.

Want help converting Ziggy Elite Triple burner natural gas into LPG

Replacing my old gas cooktop with a new induction cooktop. Gas disconnection is being handled separately. Looking for a licensed electrician to: Install and connect the induction cooktop Run a new dedicated circuit from the switchboard if needed Provide a certificate of testing and safety Cooktop model: Westinghouse 70cm. Existing cutout: 61x49cm. Please include your electrical contractor licence number in your offer. Happy to adjust the budget if a switchboard upgrade is required.

I'm replacing my gas cooktop with induction. The electrical side is being handled separately. I need a licensed gasfitter to: Disconnect the gas cooktop and safely cap the gas line Remove the LPG regulator and outside pipework/bottle connection (the bottles are already disconnected) Issue a gas compliance certificate

Licensed, insured plumber/gas fitter required for kitchen renovation in a Windsor QLD unit. Target October 2026; two coordinated visits. Indicative budget $1,900 including gas scope. Quote incl. GST if applicable. VISIT 1, BEFORE DEMOLITION: isolate and disconnect existing kitchen sink/tap and make water/waste connections safe for strip-out. Retain existing service locations. VISIT 2, AFTER CABINETS/TOP: fit and connect our supplied new sink and kitchen mixer, basket wastes where not supplied with sink, traps, isolation valves, connectors and minor under-sink pipework. Include necessary plumbing fittings/consumables, testing for leaks and completion documentation applicable to the work. WE SUPPLY sink and mixer. Confirm selected product and what waste fittings come with it before buying duplicates. Cabinet installer makes top openings using the sink/tap templates. Coordinate sink mounting and sealing with installer so nothing is omitted or charged twice; include final sink mounting/sealing in your offer. Slab and brick/block walls retained. No new pipe route, slab chasing or structural drilling allowed in base scope. Identify defective existing services and separately price repairs before proceeding. No dishwasher/fridge-water installation currently included. ASSUME RETAINED GAS STOVE. Include licensed gas isolation/disconnection before demo, safe capping, then reinstatement, compliant connection, securing as required, testing/commissioning and applicable gas documentation. Confirm model and existing supply suitability. Itemise plumbing and gas portions. No new stove supply or gas relocation. Major upgrades separately quoted. Any oven electrical connection by electrician. 3D image is a proposed reference; verify dimensions on site. State licence, insurance, availability for both visits, labour/material split, exclusions and responsibility for any required notices/certificates. Coordinate shared water shutdown/access with us before work.

Looking for a gas fitter to provide and install natural gas injectors to convert a bbq from LPG.

Quote for installation of gas hotplate and installing gas to kitchen

The hot water is not working to the kitchen tap. Alsothe gas stove top is not getting any gas to it. Hoping to get fixed this weekend if possible other wise next weekend at the latest

We have an Everdure 4-burner gas cooktop in our townhouse and the gas pressure/flame from the burners is currently very weak. The cooktop still lights and operates, but the flame output is much lower than it should be and cooking takes considerably longer. We own the townhouse and have access to the property's gas meter/regulator. Photos of the cooktop and gas meter are attached. Looking for a licensed gas fitter to: - Diagnose the cause of the low gas pressure/flame. - Check the gas pressure at the cooktop. - Check the cooktop/burners, jets and appliance regulator if applicable. - Check whether there is an issue with the gas supply, regulator or line feeding the cooktop. - Rectify the problem if it is a straightforward service/adjustment/repair. - Let us know if any additional parts or larger repairs are required before proceeding. Licensed Queensland gas fitters only please.

Check and swap over gas bottles

Need someone to replace and reconnect 2 x 8kg swap and go gas bottles. Price inclusive of gas refill ($40 per bottle)

Need Licensed Plumber – Decommission Gas Line. Looking for a licensed plumber to safely turn off and cap an existing residential gas line. The gas supply is no longer required as the appliance has been removed. Need the job completed ASAP. Please bring any fittings required and provide a gas compliance certificate if applicable. Flexible with timing and happy to meet on site at short notice.

I’m looking for a licensed gas fitter to inspect and repair an LPG gas leak at my home. The leak appears to occur where the pigtail/hose connects to the LPG gas bottle. I need the issue diagnosed and repaired safely. The task includes: * Inspect the LPG bottle connection and pigtail. * Diagnose the source of the leak. * Repair the leak if possible. * Replace the pigtail, fittings, seals, or regulator if required (parts can be quoted separately if needed). * Test the system after the repair to ensure there are no leaks and it is safe to use. I’ve attached photos of: * The LPG bottle valve. * The pigtail/hose connection. * The regulator and gas line. * The overall gas installation. Please only respond if you are a licensed gas fitter and can provide the appropriate compliance paperwork if required.

We have just purchased a fish & chip shop and need to disconnect the existing gas appliances in the kitchen as we are selling them. There is 3x deep fryers, one gas stove top/oven and a front display fridge. Want it to be done by a licensed gas fitter/plumber. Location is in Wynnum and ideally want it done over the next few days.

I need to shorten the gas pipe dont know the price so kept it roughly as I had to keep it the has pipe goes to the floor and I am doing a concreting so need to make it shorter than that

Need a qualified plumber to fix the small gas leak near the valve.