Find an experienced gas fitter in West Melbourne

middle burner turns on but does not stay on once the nop is released. The fire sensor issue defective need it replaced.

Supply and install a 15 mm gas isolation valve to cooktop to allow shut off for servicing / emergency Supply and Install a tempering valve and thermal lagging to hot water unit piping where required will need compliance certificate for all works

I recently had a minor gas leak and detection completed. There were 2 minor leaks identified in the locations shown in the photo. The pipe that requires repair is at a distance or approx 1.5 metres from the gas meter (very close). The pipe is only about half meter from ground level and very easily accessible. If a replacement is best, then note that the 2 leaks are 60cm apart from each other. Once repaired it will require a couple of clips to secure to the brickwork. The job requires 1. Repair pipe or replace the affected length with new (2 leaks are 60cm apart on the same pipe length) 2. Run a test at meter for gas leak to check it’s resolved and report result 3. Provide a certificate of completion. Must be a licenced gas plumber. Flexible with time of day. Happy for after hours timeframes / after work to suit you.

Licenced gas plumber required to replace the gas burner. I need quotation first and then fully install.

Needing gas plumber to fix this stove/oven set up and to make it safe and up to code

Title: Gas fitter needed — stove burner plate replacement + secure ducted heater flue (Hillside 3037) Description: Licensed gas fitter needed for a rental property in Hillside VIC 3037. A gas safety inspection recently failed on two points: Stove top (built-in gas cooktop) — worn burner plate/base cover causing flame lift-off, needs replacement to meet AS/NZS 5601.1. Ducted gas heater — flue isn't properly supported at the roof penetration and needs to be secured. Looking for a fixed quote covering both items, plus a compliance certificate on completion. Please quote labour + parts, and let me know availability for the next 1–2 weeks.

I would like to maintenance check for Gas cook top for leak test or safety test

I have a Thermann gas storage unit. The water out of the PTR valve is boiling hot but all my internal taps are lukewarm, so I need the tempering valve replaced.

Gas cook top need to fix

Need the gas checked at the property to ensure no leaks etc with an accompanying certificate of compliance. Note : the only gas appliance is the gas hot water unit.

Please run gas pressure test at shop.

I have a solar boosted gas hot water instantaneous unit with tank. Need to get it repiped and convert to just gas instantaneous unit.

Gas pilot has been off for more than 2 weeks. A licenced plumber needed to ensure hot water and ducted heating is accessed 24/7 to home.

Need a check for any carbon dioxide and syncing for the remote.

Hi, I’m looking for a licensed gas fitter to inspect an already installed gas cooktop. Just need a quick check of gas connections, leaks, and overall safety/compliance, and a compliance sign-off if all is okay. If required, a gas isolation valve may need to be added underneath the cooktop. A cement sheet has been installed behind the tiled wall for heat protection due to slightly reduced clearance (around 125mm). Original installer is unavailable, so just after a routine safety check for peace of mind. Location: Melton west, 3337

Needing valves looked at maybe replaced on a stove. I brought new switches hoping that would fix issue as some are not igniting the burner.

Need to disconnect and block off gas stove. Also check for leaks while in there so it’s not left dodgy, but also shut off mains as gas is no longer needed. I’m getting the stove removed the following day hence the deadline. Can be any time on Tuesday from 9 until late. Other info: single story home, about 80 years old.

I have an existing gas heater that needs to be decommissioned, including capping and making safe services connection. Disposal of the redundant unit is my responsibility. Need a licensed gas plumber to do disconnection of existing gas heater unit.

Remove Gas Heater and Cap the Gas line. Gas heater is in working condition. Happy for you to take it if you want as I no longer need it.

Replace my gas burner . Cut the laminate board bench to the new size and replace the burner