Find a local timber flooring profesional in North West Melbourne

Stain timber deck = 7m*5m=35 m² Paint bamboo fence = 34m Stain for deck and bamboo supplied by client. Quote for labour and cleaning the deck and bamboo to prepare for the paint.

Hi there, I’m looking for an experienced carpenter to build a raised deck at my property in Kalkallo. Job details: * Approximate size: 5.5 m × 3.2 m (17.6 m²), subject to site measurement * Timber or composite decking * Built-in L-shaped bench seating along the rear and side fences * Narrow planter beds behind both benches * Finished deck approximately 100 mm above the existing concrete pathway * Existing ground approximately 300–500 mm below concrete level * Access via a 1.2 m-wide concrete pathway I’m also planning a freestanding four-post aluminium pergola in the future, so its footing locations need to be considered. I’m after competitive quotes for both supply and installation, or labour only if I supply materials. Photos, drawings and design references are available. Happy to arrange a site inspection. Cheers, Jacob

• Front Zone: Multi-tiered entry deck, including vertical steps, risers, and matching timber planter bed borders. • Rear Zone: Laundry sliding door landing pad, the long walkway strip connecting the garage to the backyard, and the integrated timber bench seat. Scope of Work Required: 1. Surface Preparation: Inspect previous coating. If patchy, strip back using an Intergrain stripping agent. If the finish is structurally intact but faded, scrub and revitalize the timber using Cabots Deck Clean prior to oiling. 2. Coating Application: Apply two coats of water-based Intergrain UltraDeck (Merbau tint) to all specified areas. 3. Application Method: Must be applied smoothly using a dedicated sheepskin/wool sock decking applicator pad to avoid lap marks.

Looking for someone to sand back our timber deck, about 39 m² (7.6 m x 5.1 m). Sanding only, I’ll do the staining myself. The exposed section is grey and weathered, the part under the alfresco is in good condition. Pics attached.

Replace Tasmanian oak timber floor boards of a bedroom of which size is 3x3.3m.

Need to sand and polished timber Floor. 2 boards are chipped so need to be replaced if required. Photos attached with the home plan. Areas: 1x Master Bed, 1xLiving, 1x Kitchen Meals 3xBedrooms

Outdoor timber pergola floor restore – clean, prepare & re-oil/recoat Looking for an experienced handyman to restore my outdoor pergola floor. The timber is dull and needs cleaning, preparation and re-oiling/recoating to bring back its colour and finish. No sanding unless necessary Approx. 6.70mt x 3.30mt Location: Roxburgh Park Please quote TOTAL including all materials and extras

Interior state case with 14 timber steps, to be sanded to raw timber, then apply varnish. I’m happy to provide the varnish

Timber floor burnt mark repai

Timber Flooring – Sand & Polish Looking for an experienced timber flooring professional to lightly sand and polish approximately 32.5 m² of 4-year-old timber flooring. 📍 Fawkner, VIC The floor is in good condition and just needs a freshen-up before the next tenant moves in. Please message me your best quote and availability, Thanks!

I have a small area perhaps 2.5x 3.5 of courtyard under a pergola that I want a deck put in. Looking for someone to build the deck and potentially some raised garden beds

Hello , I have a small rear timber deck, which needs to be removed and new composite decking to be installed. I will supply the new decking and materials, need someone to install the new decking at a reasonable cost..thank you

Add 63-65mm hardwood timber floorboard in picture 9 timbers

Install engineered timber flooring in living, entrance, butler pantry and passage. 86sqm

I need a guy who can sand and polish the timber floor. I have all tools with me. One of my guy is away for few days.

Trying to lay timber wood floor second floor hallway is not even.

A have a few little patches that need to be colour match with vanish to create smooth colour finish

Looking for an experienced timber floor repair specialist to fix burn marks on wooden floorboards caused by hot coal/embers. Damage is mostly superficial and does not appear deep. There are 2 affected areas: * One area has several small sprinkle-like burn marks scattered across the floor (similar to water splash marks) * Another area has a cluster of slightly larger burn spots around 1–2 cm in size Photos attached for reference. Looking for someone who can: * Sand/blend the affected areas * Reduce or remove the black burn marks * Match the timber colour and finish as closely as possible * Avoid replacing boards if repair is possible The floor is otherwise in good condition. Please comment with: * Your experience with timber floor restoration/spot repairs * Estimated quote * Availability

Some heavy furniture has damaged/scraped off the Vinyl flooring in a couple of places and it needs to be spot-repaired

Hi, I am after someone with decking experience to help set up a timber deck over this existing verandah, as minimal as possible framing underneath as this is a concrete slab and I don’t want to create a large build up of the level. Please in your description tell me how you would approach this and photos of previous experience and what your price includes. It is roughly 24sqm