Find experienced local fencing contractors in West Brisbane

we need privacy n the backyard - and the existgin side fence line is only 1.2 mtres high - we request about 15 mters of that be replaced with 1.8 mtr high fence - pickets

Installation of pre-bought aluminium gates. Gates bought from Future fence including all attachments, hinges, fixings etc. Works as follows West Double Gates: - Fixing of posts to timber battens - Cutting of base of gates to suit ground level (reduced from 1200mm to 1050mm and 1100mm) - Attachment of hinges and gates - Installation of latch East Single gate - Installation of single inground post - Installation of fixed section including reduction in height (1200 to 1050mm approx) - one side fixed to block wall - Installation of gate including latch Installation guidelines here: https://futurefence.frontkb.com/en/categories/548481-installation

Looking for a handyman/fabricator to supply and install a custom solid swing gate at the entrance to our restaurant kitchen/staff area in Jindalee. The opening is not perfectly straight/square, so it will need to be measured on site and made to fit properly. Requirements: * Solid gate – no bars or see-through gaps * No gap at the bottom as we need to prevent rodents/pests entering the kitchen area * Gate should fit the uneven/angled opening as closely as possible * Preferably black to match the existing shop fit-out * Strong and suitable for daily commercial use * Hinged/swing opening for staff access * Easy to open from inside * Secure latch/closing mechanism * Neat and professional finish Photos of the area are attached. The current ones and AI created example picture too.

Experienced Fencer Required – The Gap – Complete by 12 September Looking for an experienced fencer to supply/install and complete fencing at our new-build property in The Gap, Brisbane. Landscaping and preparation for new turf are currently underway, so I am looking to have the fencing completed as soon as possible and no later than 12 September. Quote required but indicative budget $8k Scope: There are 3 sides requiring fencing: * 2 sides are along existing retaining walls and the fence will be installed using the existing shark-fin fence brackets/posts – no ground posts required along these sections. * 1 side requires posts to be installed into the ground. This side also provides access to the backyard, so I would like this section prioritised before final turf preparation and installation. * Installation and completion of fencing across all three sides. * Removal of post-hole spoil and construction debris on completion. * Site left clean and ready for final landscaping/turf. The yard is currently unturfed, which provides a good opportunity to complete the fencing without needing to protect an established lawn. Timing is important: the entire landscaping/fencing project needs to be completed by 12 September, so preference will be given to someone who can inspect and commence promptly. Please include in your response: * Relevant fencing experience * Earliest availability * Confirmation you can complete by 12 September * Whether you can supply materials or prefer materials supplied * Examples/photos of previous work * Whether you are insured * Indicative price or whether you would like to inspect before quoting Photos of the property and current retaining walls/shark fins are available. Location: The Gap, Brisbane

Looking for an experienced fencing contractor to remove and dispose of the existing chain-wire fence shown in the photos and install a new Colorbond fence. Job details: * Approximately 28 metres of fencing * 1.8 m high Colorbond fence * Colour: Woodland Grey * Treated pine sleepers underneath the fence * Supply and installation of all posts, rails, Colorbond sheets and sleepers * Demolition, removal and disposal of the existing fence * Property is on sloping ground, so please allow for this when quoting * Existing vegetation is close to sections of the boundary, as shown in photos

Quote for new fence, 1 quote for all hardwood, the other quote for hardwood posts and rails with pine pailings. Fence measures approx 19.58 mts, height 1800. One side capped, other side spaced 75mm apart, all fence capped on top. Remove existing wood fence and stumps.

As per images the gate at the side of the house won’t close properly. Something must have moved / expanded as it’s very off.

1. Scope of Work Supply and installation of a 1200mm high frame less glass pool fencing system. Layout features a 3-sided enclosure intersecting with a timber pergola structure. 2. Key Specifications & Components Glass Panels: 1200mm high toughened safety glass (10mm or 12mm thick for frameless applications). Posts / Spigots: Must use non-conductive spigots/posts. Hardware must be a Silver Finish. Gate: 1 x 900mm wide matching glass gate equipped with self closing, lockable self-latching mechanism. Compliance Certification: Quote must include a Form 15 (Compliance Certificate for Building Design) 3. Layout Dimensions & Linear Meterage Please refer to the attached site diagram (red lines indicate the precise fence trajectory). Total Linear Meterage: Approx. 9.5 - 10.0 metres (inclusive of the 900mm gate). 4. Pergola Integration: The rear wall of the enclosure is a timber pergola structure. The fence on the left and right sides must seal cleanly against this timber structure to eliminate any bypass gaps (>100mm). 5. Substrate & Site Access Substrate: Tiled concrete slab. Spigots must be carefully core-drilled through the outdoor tiles into the concrete slab below without cracking or damaging the surrounding tiles. Pergola Fixing: The left and right glass runs require appropriate wall-mount/post-mount hardware (matching silver finish) to securely affix directly to the timber pergola posts. Site Access: Clear, direct access to the rear yard via a side gate. 6. Submission Requirements Please provide a detailed, itemised quote breaking down: Materials (Glass panels, non-conductive silver posts/hardware, matching gate kit, wall brackets) Labour / Installation cost (inclusive of tile core-drilling) Estimated lead time for commencement of works Estimate duration of works Warranty terms on hardware and installation work

Install pool fencing to edge of mezzanine. Also if possible to install a handrail for the stairs

Replace metal gate with new metal gate. Have new gate and fittings already.

Section of fence was removed to complete resting wall. Section needs to be replaced. 2.5 meters wide. Currently on sturdy post in place to build off. 1 extra post required. Standard timber, 1.8m high. Flat easy access to complete. Need done today.

Take down and remove from site 50Lm of chainlink fencing, including dumping, ready for new fence install. Posts cut off and ground level.

Colorbond fence as discussed

Repair / Replace Timber Picket Fence – Approx. 8 Posts Description: Looking for an experienced fencing contractor or carpenter to repair an existing timber picket fence. The fence has leaning sections due to failed timber posts. The job will involve: * Remove and replace approximately 8 timber fence posts * Reinstall the existing fence where possible * Reuse existing pickets and rails wherever they are still in good condition * Replace any damaged rails only if required * Ensure the fence is straight, level and securely concreted into the ground * Dispose of any damaged materials (or stack neatly on site if preferred) The fence is approximately 15–20 metres long (please adjust if needed). I’m looking for someone who has done similar fencing work before. Please provide: * Your quote (labour + materials) * Estimated timeframe “Open to quotes. Preference is to repair the existing fence by replacing the posts and reusing as much of the existing timber as possible rather than replacing the entire fence.” I’ve attached photos of the existing fence for reference.

Please can you quote me to install glass fencing around the pool. 9.57m along the long side and 5.9m across the short side. The are to the right on the short side needs some concrete between the pool and the wooden garden fence.

Chapel Hill, QLD 4069 Need a fence installer for about 42m of fencing. Rough split: - 18m Colorbond - 18m lapped and capped timber fence - 6m stepped timber corner - 2m timber to match neighbour fence I have Colorbond sheets and rails on site. I likely need you to supply posts, caps, screws, concrete, timber, paint and other bits. Fence goes in front of a sandstone retaining wall, close to the boundary. Ground is clay and sloped in parts. Wanted: - Around 2m high, or highest simple/legal height - Solid posts, set deep enough for clay soil - Lapped and Capped Timber Fence painted Monument - Small 2m neighbour match section left unpainted - Colorbond does not need paint - Simple, neat, strong finish - Clean up after Budget is indicative but limited - please provide detailed quotes and when you can start and how long it would take. Site ready for work to start today. Photos/sketch attached.

Fence has been damaged by a falling tree. Need it repaired asap.

We have an existing glass pool fence that requires repair. The stainless steel spigots are in good condition, however the anchor fixings have rusted and need to be replaced. Note that each glass panel will need to be removed to access the bracket fixing points (2 person lift that I can assist with).

Fence needs repairs, please refer to photos attached. Repairs will likely involve rehanging the gate, replacing hinges/brackets, straightening/re-alignment of gate and potential timber reinforcement.

Tasks include: 1. Take down 45 linear metres of wooden fence - you can leave the fence posts for when we have the machinery on site. Fence materials to be placed neatly next to the property for reinstallation later. 2. Take down approx 17.5m colour bond fences and put materials next to the house for reinstallation later 3. Moves a pile of wood to next to the house No removal/dump run is required. No need to remove the fence posts. Would like done anytime between 31st March and 6th April. Must be completed by 6th April with preference for 2nd April completion. Let me know your quote and when you'd be able to do the task.