Find experienced local fencing contractors in QLD

I have 5 posts I want cut and removed from garden . I want them cut at the bottom of the metal post so I can cover the ground with new stones.

Pour concret slab ( or a mix of slab and pavers ) to consolidate garden fence. As per the picture, the concrete around the fence’s posts is now above ground. I’m open to any other ideas. Please supply all materials.

Install 3x shapescaper garden edge steel strips along a small 5 meter colourbond fence: - grind the 3x steel strips to the correct lengths and cut out gaps where needed to make way for concrete fence posts. - screw the steel strips into the fence - bend 1x steel strip to form an L-shape between the driveway and fence post around the postbox I already have all materials (2x 230mm by 2400mm steel strip, 1x 150mm by 2400mm steel strip, stakes, screws). I have also already excavated the area so no need to dig or remove soil.

Looking for someone to supply and install a gate at my property. • Height: approx. 1800mm • Width options: • Single gate approx. 1600mm wide, OR • Gate 1000mm wide + fixed panel 600mm • Material: Steel Colorbond vs Aluminium. • Needs to be sturdy, safe and secure. • Location: Spring Mountain QLD 4300 • Flexible with design suggestions and availability. Please quote including materials, labour, and any fixings needed.

My dog is trying to dig under the fence to escape - wanting to somehow secure it.

Needing a gate to be built into garden.

The person have get all materials to make the shade oneself

GARDEN EDGE CUT 30 MILLIMETRES OFF THE BRICKWORK GATE POST TIMBERS CUT OFF APPROXIMATELY 160 MILLIMETRES ABOVE GROUND LEVEL.

To dig holes for fence posts

Project Overview I need a sturdy, pest-proof enclosure built over an existing 8 m × 4 m garden bed so that insects, birds and small animals can’t reach my growing produce. I’ll supply the 2.4 m RHS steel posts and instant-mix cement; I will pay for materials. Scope of Work 1. Frame Installation Posts: Set ten (or as required) 2.4 m RHS steel posts into concrete footings around the 8 × 4 m perimeter. Spacing & Layout: Posts should be spaced roughly 1.5–2 m apart to support side rails and netting securely. Concrete Footings: Use instant-mix cement to anchor each post plumb and level. 2. Side Rails & Support Rails: Install horizontal timber or metal rails between posts at two heights (e.g. 0.5 m and 2 m) to attach netting. Bracing: Add diagonal braces or top cross-members to stiffen the frame and prevent sagging. 3. Pest-Proof Covering Netting: Secure fine-mesh insect netting (2 mm mesh or smaller) tightly around all sides and over the top to keep out birds, insects and small mammals. Access: Build one wide lockable hinged or removable door/section for easy entry, harvesting and maintenance. Wheelbarrow should fit comfortably. 4. Finish & Weatherproofing Fixings: Use corrosion-resistant screws, bolts and clips suitable for outdoor use. Sealing: Ensure any timber is treated or painted for exterior exposure (I can supply paint), and netting edges are neatly trimmed and secured.

Repositioning of existing colorbond fence and the addition of a side fence and gate and cane toad defence.

Around 20 meters of low lying fence for garden area with posts going into concrete, and dug into dirt. 1 or 2 gates / entrance points. Style same as fence in picture with 2 top railings and link fence below - however just not as high as the picture fence, smaller version. Budget is only to post job - quote what you feel it would cost.

Need to fix garden gate, we can't lock it, ?need extension

Needing two garden fences put in with gates, first fence will be 3m other fence is 2.3m (materials will need to be supplied) - Please see photos for reference

As described. Remove and install single side gate .

The timber garden gate urgently needs repair. The supporting post at the base has become loose, and the central post shows a large crack in the wood. As a result, the gate has fallen over. Immediate repairs are required to secure the loose post and either reinforce or replace the damaged central post to restore the gate’s stability and functionality.

1 post of trellis has fallen over and pulled out of the ground. Needs to be stood up and concreted and/or braced.

2 fences with gates for animal enclosure, and boundary fencing to contain dogs to part of garden. Will need to view to quote.

AirTasker Ad: Replace 3 Fence Posts (Side Garden Fence) Looking for a skilled handyman to replace 3 fence posts. The job will require digging under a slab from the neighbor's side to access and remove the old posts. Or erecting new posts from neighbours side. There are 4 steel posts on site if required. Details: Remove and replace 3 posts. Digging under a slab required for access. Must have own tools and materials (if needed, we can discuss supplies). Careful work to avoid damage to surrounding areas. Please provide your experience, availability, and quote. Flexible with timing but would like it done soon!

Hi. We need to get 2 old style garden gates fixed to make them close better. I tried to fix the latch on one of them but it wasn't great. Please can you let me know approximate cost and availability. Thanks, Wes

I need to put in a couple of gates into the front and side of the property. Currently there is a half height gate ( 1m wide gap including posts and gate);at the enterance, I would like to make if full height. To the side.of the property there is a approx 1.8m wide space which requires a full height gate and panel. Happy to discuss design and materials, slatted black metal is what I'm hearing from the boss.

Ok so you’ll have to look at photos but I need to move stairs and stringers to different location… stringers are currently concreted in at base. Also need three stirrups installed in concrete to go between fencing - see pics … maybe able to re-use timber on stairs otherwise can purchase more and install myself at at later time - will also need railings down both sides of stairs to match fencing - have fencing but don’t have railings - please contact me for further info as I’ve just put in a price and have no idea goes much it will be so hit me with your quotes

Front boundary for purposes of building a fence.

Hi there, I’m looking for a reliable person with experience in cat-proofing backyards to help make my existing fence escape-proof for two cats. • Property: Fully fenced residential single story home (standard fencing) I’ve uploaded a couple photos of the fence for reference. • Goal: Prevent cats from climbing over the fence while keeping the yard looking neat and tidy • Options open to: • Installing cat-proof rollers (e.g., Oscillot) • Angled brackets with mesh/netting • Any other effective, professional solutions you can recommend Requirements: • Must provide your own tools and materials (unless discussed) • Previous experience with pet containment or fencing preferred • Please include photos of past work if possible Budget: Please provide your quote (labour + materials). Open to negotiation depending on the solution offered. Timing: Flexible — ideally within the next few weeks, or ASAP if possible. Looking forward to hearing your ideas and getting my cats some safe outdoor freedom! Thanks

Mesh flooring to stop dogs from getting out

Need mesh for bottom of fence inside yard to stop digging and possibly extend fencing 1m higher. Need it before 3rd of september but am flexible

Need to have current colourbond driveway gates moved from current location back about 10 metres

My dog is trying to dig under the fence to escape - wanting to somehow secure it.

- take out existing colorbond fence - install the colorbond fence with new posts at a different location

I need around 100m of rectification to a 1.8 meter fencing. They were completed not straight and rectification of a cement retaining wall.

We need a low wood fence (1-1.2m tall) fence to enclose a dog run in our backyard. It will need two gates for access. Approximately 25m fence length total. Photo of the area to be fenced.

Needing this pet gate installed on a bedroom door upstairs.

Moving to new house in Maroochy River on 29th August. Will need a dog fence / run built for our 2 dogs as the property is not fenced. Something relatively aesthetically pleasing - but cost effective. Size approx - 4 x 10 metres - rectangle enclosure with gate. Or happy with farm style wooden fencing - with wire to stop them getting through Please provide quote. Large dogs: English Staffy & labradore

Sheep going on to neighbouring property No idea how much and a quote would give me an idea

Wanting someone to come and measure the back fence and go buy plywood and screws to board up the back fence as well as place/screw it to the fence. New neighbours dogs are harassing mine and want the fence blocked out. The fence is behind a hedge. Price is negotiable.

In need of temporary dog fencing installed around certain areas of my yard for my 9 week old puppy. Dog mesh and stakes will be available

50-100m of fencing. Just need staples hammered in on top rail to hold fence up- 30minutes work tops

I need a dog proof gate for back end and also one in the front under the existing gate where there is an opening. I want to make sure the price includes labour and material. I would prefer if this can be done either on thursday or friday this week. I have attached the pictures for front and back section. The height of gate need not be that big as we have is a puppy so probably half a meter.

Make a proper door for dogs between 2 unit .

Looking for a handyman to build a pet fence and gates for a small areas beside our house. We have a gate that also needs to be repaired.

I need someone to install Colorbond fence for 8m Including 1m gate

Wind has taken colour bond fence. Seems the concrete has cracked and rest of fence starting as well from other concrete poles starting to stress.

32 metre side fence colour bond with potential front fence with electric gates at 29 metres

The 2 large wooden driveway gates need to be replaced (& disposed) with colourbond gates.

Need +/- 50m of either timber or Colorbond fencing erected. Contractor to supply if timber. I will supply if Colorbond.

Looking for an experienced fencing installer to remove existing fence and then supply and install approximately 68 metres of Colorbond fencing at my property in Capalaba. - Require supply of materials and installation - Require old fence to be removed and disposed of - Open to offers/quotes

20 meters fence in a flat land. Accessible and no existing fence. Colourbond

Align and secure colourbond fence panels

I need two posts supplied and put up against a colourbond fence to attach a washing line to , they also need to be cemented into the ground , photos of the line and fence are attached, the posts need to be in colourbond colour monument

Demolish and dispose of the old timber fence. Build 41m of new Colorbond fence Shale Grey, exactly the same as per the photos: 1.8m height, with most bays having 1 sleeper underneath, about 5 bays with 2 sleepers underneath. Sleepers painted with two coats of matching colour - I will provide the paint) About 25m of the fence line has the same height, then diagonally stepping down as per the photo. Due to sandy soil, all posts to be dug in 800mm deep. (photos show shark fins, however this new fence posts will need to be dug in.) I am able to provide all the material, please quote separately on material and labour, or labour only. Thank you.

We installed a colour-bond fence ourselves a few years ago and let’s just say we are not professionals. Some panels lean, some move in strong winds, the gate can open itself haha. Really need help securing this to keep the pets safe in our yard

Need supply and installation of colorbond fence 1.8m, around 9 to 10 meters in total. Old fence at neighbour stays, removal not required.

Need new panels put in for a length of 2.4 m roughly - colour - Riversand. - existing ones have some holes put in so need to be changed to new panels (I believe 3 panels make up 2.4m within the section. I am not sure of the cost. please quote your hourly or for full job.

Remove old wooden paling fence Discuss style and colour of new colour bond fence Supply and install new fence

Install 8 2400high x 1200 wide galvanised mesh sheets to colorbond fence. Job is ready to go. Easy access i got clips & surfmist screw fixing. i can give a hand with the install as well. colorbond fence is 1800 high.

Supply and Install surf mist colorbond fence panels between block pillars on retaining wall as per below gap sizes Hole 1 (Left): 1530 h Top-1235 Middle-1235 Bottom-1235 Hole 2 Middle): 1520 h Top: 1180 Middle: 1180 Bottom: 1180 Hole 3 (Right): 1530 h Top: 1445 Middle: 1445 Bottom: 1440

One of the colorbond fence panel flew off during cyclone Alfred. Fence panel needs to be reattached. I do not own a ladder

Need the fence removed and new fence built, hopefully in one day as the fence divides 2 units. The colour bond has to match the other fences in the complex in colour and style.

Remove colour bond fence and stack neatly Fence is to remain on site stacked neatly You will need a ladder and a battery drill/driver to remove screws

Supply and install new Colourbond fencing, approximately 1800mm high. Colour: Surfmist (posts and rails also Surfmist). Include timber sleeper (200x50mm) at the base. Complete removal and disposal of the existing damaged fence (partially broken due to recent cyclone - photo attached for reference). Site clean-up after completion. We have received a quote of $4500 for this work (including $500 for rubbish removal). The contractor who provided is busy and cannot make it in the next few weeks and hence reaching out to Air Tasker. Please provide your best quote. Thanks for your consideration.