Find experienced local fencing contractors in WA

Two wooden gates swollen in the rain, need repairing and re-hanging. May need to lower paving immediately under the gates

We have a pets electric fence. We need to get somebody to make sure that the fence is free from plants. It's mostly fine -- I am showing in the photos the absolute worst bit. The job is to make sure that the fence is totally clear of plants.

Wanting a timber picket fence built to front garden. Approx 3.5m x10m x7m (including gate) maybe 1200 high? Want old school pickets. Empty yard so nothing to remove first. Open to suggestions. I’m happy to paint it myself once up. Thanks in advance. This is the house and yard with a suggested picture of the fence.

Need a new gate installed, preferably not wood. 1100 wide and 1700 high approx

Pull down and remove 6m of asbestos fencing and 1 lattice full height panel Install 6m x 1800mm high colorbond fencing using ally wall where needed for retaining. Fence to be installed between my unit and my neighbours in the back garden. Fence installation without existing asbestos fence removal can be quoted for, ie separating out the removal and installation.

We had a handyman build a fence and he was going to fix the gate but has become unwell so we need someone to finish the job! We need a garden gate fitted. We will source the gate, but not the hardware to fit it, so you’ll need to source brackets, screws etc.

I am looking for a handyman or tradesperson to install a self-closing spring or hinges and a latch on a garden side gate. Job details: • Install a spring for self-closing function on garden side door • Install/adjust hinges as required • Ensure the gate closes properly and aligns correctly prefer someone with Own tools and equipment.

Small aluminium fence with 2 gates approx 1200mm high x 2100 wide

One of my timber retaining wall posts has failed and needs to be replaced. I’ve already removed the old rotten post (see photos) and taken measurements to assist with quoting. Please: Supply and install 1 new treated post Secure post to support the upper sleeper beam and stop further collapse Must be structurally sound and weather-resistant Preference for someone with landscaping or carpentry experience

11m fence install. Already have the supplies.

Build a fence around veggie garden to stop dog digging holes! It is roughly 7m of fencing needed and no more than 1.5m high. Something super simple made of wood or pallets. Thanks

Install garden barrier to bottom of colourbond fence with tek screws. We have the garden eding and tek screws. Will need to difmf sand back from fence to install. This is a new build. Approx 24 metres.

I need 2 wooden slats reattached to my front garden fence.

For front fenced lawn, I need metal slate gate ( Matching slats). It will be 2 doors of approximately 1 meters by 1 meter.

- Ground is rocky and gravelly in some areas - Ground is hilly in some areas - Can be made how you like as long as it works and is secure

I need my garden gate replaced. Its a standard 90x150 arched timber gate. I would like you to: - Supply the new gate - Swap over any hardware from the original gate to the new gate - Hang the gate - Dispose of old gate

Colour bond garden gate needs lifting as it has dropped and is difficult to open. Scraps on the ground

Jarrah closed picket, wooden gate has been sealed and painted. No hardware or posts included. We need you to create infill for this to fit. Size of gate - 180cm x 90cm Size of gap - 116cm $200 plus costs

I need 2 x identical garden gates installed in my front courtyard. They are 1800mm high x 900mm wide & the wall openings are 1000mm wide, so will need timber to fill gaps (you to source & supply). I already have the hardware (hinges & latches), which also need to be installed. Require proof you've done this sort of thing before.

Hello I need some general gardening, installation of reticulation and also I would like wires to be installed on all my fences so I can train star jasmine.

Put up a dog fence area (fence materials will be provided) Type of gardening: Other Size of garden: Under 50m² Has green waste bin: No

Needing an area fenced for dogs. Putting $123 for price as open to quotes. Open to both wooden and wire options.

We have a pets electric fence. We need to get somebody to make sure that the fence is free from plants. It's mostly fine -- I am showing in the photos the absolute worst bit. The job is to make sure that the fence is totally clear of plants.

Swing gate relocation (removal and install) to front fence + supply any materials needed for the job.

Drilling small posts into colorbond fence and then the oscillot rollers. 4 x 2m lengths.

I need urgent installation of the Oscillot cat‑proof fence system. Details: • Install Oscillot rollers around my Colorbond fence perimeter • Add one small inward‑facing net panel in a corner with tall vegetation • Minor gate tweak (small internal net square or inward cap) Please let me know your earliest availability — the job is time‑sensitive. Thank you.

I need a dog fence installed in my courtyard area (see photo attached with red marked section). Details: • Approx length: 6–8 metres (straight run) • Surface: paved/concrete • Height required: approx 90cm–120cm • Secure enough for a medium-sized dog • Would prefer black powder-coated panels (open to suggestions) • Must be securely anchored (not temporary plastic fencing) Please quote including: • Labour • Materials • Any drilling/bolting required Please quote total cost including materials and installation for approx 6-8m dog fence. Thanks!

New Gate and Fabrication similar to photo below look for measure and quote

I am looking for someone to supply and install a wooden gate/fence (custom built to size) in two outdoor areas of my property. This is not a decorative job — the main purpose is containment for a cat/dog, durability, and safe access. The $1200 budget is inclusive of all materials and labour. Area 1 • Total width: ~ 142 cm • Requires: Gate + fixed fencing • Height: ~180 cm • Minimal gap at bottom (must be pet-proof) Area 2 • Total width: ~ 253 cm • Requires: Gate + fixed fencing • Height: ~180 cm • Minimal gap at bottom (pet-proof) General Requirements Materials: Simple and durable open to suggestions. Finish: Doesn’t need to be fancy functionality over appearance Gate: Lockable or latchable Bottom gap: Must be small enough that a cat or small dog cannot escape Supply & install included Must be suitable for outdoor use I’ve attached photos of both areas for reference. I’m happy with practical solutions and open to suggestions that keep costs down while remaining secure.

In need some Oscillot cat fence toppers installed on about 15m of fence and on top of 3 fence gates

There is around 70m of fencing in our backyard. Looking to install extend fenceline up 400/600mm and install 'lean-in' PVC piping with mesh to deter the dog from jumping. Materials supplied, just looking for labour.

Require relocation of retaining wall and colourbond fence due to encroachment onto neighbors property

Hi everyone I need a side gate installed to stop my dogs escaping. Doesn’t need to be anything fancy just something that will stop them escaping

Addition to cat enclosure involves fastening 7m x 1.2m Catnet mesh to house eaves on one side, to colourbond fence on other, extending to the ground at both ends with entry to existing enclosure at one end.

Need my fence (gaps) patched up to stop my puppy escaping to neighbour house, something like the picture I instal.

Hey everyone! Due to my house being newly built I need a really good handy man to figure out a way to stop my dogs escaping. My dogs are digging under the fence and getting out.

Some basic chicken wire fencing doing. One of our dogs has become an escape artist!

The dogs dig under the fence need some dog proof wire or something installed open to suggestions

Enclosure net, brackets and all other materials have been purchased just needs to be attached to the existing fence. The enclosure doesnt enclose totally as in roof. It is fence extension brackets attached to fence and then a wire netting put along the brackets to extend fence height. Most of the fence is wood, a small part is metal and an equally small part is brick. I have all necessary attachments bought with fence extension wire. I hope this helps. Approx 20 - 25 m In my head it would take 8 hours. I am happy to work as a side kick.

Glass pool fence and fixings to be moved to new location new footings will need to be done

Need colorbond fencing done 14.7W x 1.2 or 1.8 height

Around 44 m asbestos fence removal and new colour-bond fence supply and install plus plinth.

Install colorbond fencing along retaining wall, one side is about 17m the other side is about 25m

Increase height of back fence by 350 mm. Materials supplied but not fixing screws. 12.5 metres wide.

Need an experienced person to install a colorbond fence. The site is prepped with soil removed. I can supply the aluminium plinths and fence panels and posts; I need to install the aluminium plnths, fence posts and concrete. The job is about 14 metres long, with two or three aluminium plinths forming a small retaining wall around 40 to 45 centimetres high. Work includes setting posts in concrete, lining everything up straight, and securely screwing the panels in place. This needs to be completed within the next five to eight days.

Single fence gate Type of gardening: Other Size of garden: Under 50m² Has green waste bin: Yes

I’m looking for someone to supply and install a Colourbond side gate at my newly built home in Baldivis. The opening where the gate will be installed is approximately 1,009 mm wide. I’m after a good-quality Colourbond gate that is secure and professionally installed. Please include all materials, labour, fittings, and installation in your quote. The property is a new build, and ideally I’d like the gate installed after we receive the keys in early August and before we move in. If you need any additional measurements or photos to provide an accurate quote, just let me know. Thanks, and I look forward to receiving your quote.

New house build. Need a side gate installed onto a Woodland grey colorbond fence between fence and home

I need about 5 sheets of colourbond fencing taken down for a pool dig including plinths, and then put back up after the pool has been installed

Supply and installation of roughly 18-20m long, 1.8m tall colourbond fence. To be installed in front of existing asbestos fence (not to be removed).

One Colorbond fence panel has come loose and is leaning after a storm (see photo). I’m looking for someone experienced with Colorbond fencing who can inspect it and reinstall/repair the existing panel if possible. I believe the panel may just need to be re-secured, but I’m happy for you to assess the best repair. * Located in Aveley WA 6069. * Easy side access. * Flexible with days and times. * Please bring any tools and fixings required. * If additional materials are needed, let me know before completing the work. Please provide your experience with Colorbond fencing and your total price to complete the repair.

Wire trellis to be constructed and affixed to Colorbond fence for climbing plants. Approx dimensions: 2.9m (L) x 1.9 (H) behind the limestone garden bed. 12,0m x 2.0m for the balance of the fence. Quotes kindly requested.

Remove existing sqaure panel fence and install a colourbond fence kit from Oxworks. I am happy to remove existing fence on the day if easier. 2 x 2400mm wide x 1800mm high sections which fill in between Linestone pillars. Can secure into Linestone Wall so no digging required.

I am looking at installing a triple, split height, Colorbond Gate between my garage and boundary fence over the caravan/boat paved driveway.

Scope of work: Replace up to 4 standard Colorbond fence panels (approx 1.8m) Remove 3 old post foundations and install new posts Includes removal/disposal of damaged material and installation Note on panels: Some old panels are rusted at the bottom but a few may still be in usable condition — happy to discuss reusing any good ones to reduce cost Additional note: My neighbour may also be interested in separate fencing work on their side of the boundary (separate from this scope). Note about Budget: Total Cost target: ~ $1,300 including material and labor Can negotiate labor rate around savings that can be achieve on materials side.

Looking for supply + install of a budget Colorbond front enclosure. Total width: approx. 5 m, height approx. 2.5 m Gate: Colorbond, 3 m wide for car access (swing or sliding – quote both) Side panel: Colorbond 2 m wide infill Color to match existing Colorbond panel on the right side Posts and framing as required I will remove all existing materials (old gate, lattice, bricks) Please provide: price (materials + labour), swing vs sliding options, start date, and whether inspection is needed.

I want to partially enclose my garage with one large colourbond panel in Grey Ridge. Supply and install needed, suggest site visit to confirm measurements etc. Solid brick wall to one side and post or similar will need to installed into concrete/paver.

I am looking to get someone to assemble a Colorbond gate kit (from Teamwork Fencing) and install it in place of an existing wooden gate (removal of old gate will be done by me). I have purchased the kit and have it ready for assembly. Please note that the gate posts will not be concreted in to the ground and therefore, will require cutting to size.

Install PA gate with side panel - colorbond 1.8 high 1.7 width PA gate - approx 1m width Side panel- approx .7m width Belmont area

We are wanting someone to supply and install 1 x plinth to the bottom of our colourBond fence 2380 wide